Husqvarna 15V2s AWD manual Service position for the cutting unit, Placing in the service position

Page 29

Maintenance

Service position for the cutting unit

The cutting head can be placed in the service position to provide easy access for cleaning, repairs and servicing. In the service position the cutting unit is raised and locked in the vertical position.

Placing in the service position

1Position the machine on ﬂat ground. Apply the parking brake. Adjust the cutting unit to the lowest cutting height and lower the cutting unit.

2Remove the front hood by removing the pin. (There are complete instructions on using the service position inside the front hood).

3Remove the two support wheels from under the front hood.

4Fit the support wheels on either side of the rear of the cutting unit.

WARNING! Wear protective glasses when

!dismantling the cutting unit. The spring which tensions up the belt may break and cause personal injury.

5Disengage the spring for the drive belt tensioning wheel. Rider 15V2

Rider 15V2 AWD

6Place a foot on the front edge of the cutting unit near the wheel and raise the front edge of the unit to make it easier to remove the lift strut.

7Engage the strut in the holder.

WARNING! Observe caution to avoid

!trapping your hand.

English – 29

Image 29

Contents English Rider 15V2 Rider 15V2 AWD Rider 15V2s AWDContents After the ﬁrst 8 hours Service journalPre-delivery service Dear Customer IntroductionDriving and transport on public roads TowingSerial Number Good serviceSymbols KEY to SymbolsBrake Starting instructions Safety instructions Safety InstructionsInsure your Rider General useThis is what you do Driving on slopesChildren MaintenanceTransport Location of the controls What is WHAT?Presentation Cutting unit Cutting height adjustment leverLifting lever for the cutting unit LightsFuelling Exercise care and refuel outdoors see safety instructionsRelease lever Release lever Rider 15V2 AWDStart the engine DrivingBefore starting Connecting the jump leads Starting the engine with a weak batteryDriving the Rider Remove the cables in the reverse orderOther objects which can be thrown out by the blades Cutting tipsStop the engine Maintenance schedule MaintenanceRemoving of the machine hoods CleaningChecking and adjusting the steering wires Adjusting the parking brake Rider 15V2 AWD Adjusting the parking brake RiderChecking and adjusting of throttle wire Can result in reduced braking abilityReplacement of fuel ﬁlter Checking and adjusting the choke wireReplacing the air ﬁlter Cool before starting to replace the air ﬁlterChecking the fuel pump’s air ﬁlter Check the level of the battery acid Dry-charged batteryIgnition system Replacing the spark plugCheck the safety system Main fuse Replacing the light bulbsChecking the tyre pressure When the engine is running. Mind your ﬁngersChecking the engine’s cooling air intake Fitting the cutting headTrapping your hand Removing the cutting unitReplacing the cutting unit belts Adjusting the parallelism of the cutting unitChecking the cutting unit’s parallelism Placing in the service position Service position for the cutting unitRemoving the BioClip plug Restoring from service positionChecking the blades Checking the engine’s oil level LubricationChanging the oil ﬁlter Replacing the engine oilGeneral lubrication Lubricating the belt adjusterChecking the transmission oil level Problem Procedure Troubleshooting scheduleStorage ServiceWinter storage GuardTechnical data EC-declaration of conformity Applies to Europe only Page ´z+S!r¶6H¨ Page 1151018-26 ´z+S!r¶6H¨ ´z+S!r¶6H¨