Husqvarna 15V2s AWD manual Removing the cutting unit, Trapping your hand

Page 27

Maintenance

WARNING! Observe caution to avoid

!trapping your hand.

6Press down the frame and remove the pin.

7Slide the unit in and insert the pin.

Make sure that the tongue (3) on the cutting unit engages correctly.

8Fit the drive belt around the drive wheels of the cutting unit.

9Hook up the height adjustment strut.

10 Move the support wheels to their parking position.

11Fit the front cover.

12Secure the collet spring.

Rider 15V2

Rider 15V2 AWD

Removing the cutting unit

WARNING! Wear protective glasses when

!dismantling the cutting unit. The spring which tensions up the belt may break and cause personal injury.

1 Carry out points 1-9 to put the cutting unit in the service position, see Service position for the cutting unit.

2Press down the frame (2) and remove the bolt (3). 2

1

3

3Pull out the cutting unit.

Checking and adjustment of the cutting unit’s ground pressure

To achieve the best cutting results the cutting unit should follow the underlying surface without pressing too hard against it.

Pressure is adjusted using a screw and spring on each side of the Rider.

1Check the air pressure in the tyres 60 kPa/0.6 kp/cm2/8.5 PSI.

2Place the machine on a ﬂat surface.

3Put the lifting lever in the mowing position.

English – 27

Image 27

Contents English Rider 15V2 Rider 15V2 AWD Rider 15V2s AWDContents Service journal Pre-delivery serviceAfter the ﬁrst 8 hours Towing IntroductionDear Customer Driving and transport on public roadsSerial Number Good serviceSymbols KEY to SymbolsBrake Starting instructions General use Safety InstructionsSafety instructions Insure your RiderThis is what you do Driving on slopesChildren MaintenanceTransport Location of the controls What is WHAT?Presentation Lights Cutting height adjustment leverCutting unit Lifting lever for the cutting unitRelease lever Rider 15V2 AWD Exercise care and refuel outdoors see safety instructionsFuelling Release leverDriving Before startingStart the engine Remove the cables in the reverse order Starting the engine with a weak batteryConnecting the jump leads Driving the RiderCutting tips Stop the engineOther objects which can be thrown out by the blades Maintenance schedule MaintenanceCleaning Checking and adjusting the steering wiresRemoving of the machine hoods Can result in reduced braking ability Adjusting the parking brake RiderAdjusting the parking brake Rider 15V2 AWD Checking and adjusting of throttle wireCool before starting to replace the air ﬁlter Checking and adjusting the choke wireReplacement of fuel ﬁlter Replacing the air ﬁlterReplacing the spark plug Check the level of the battery acid Dry-charged batteryChecking the fuel pump’s air ﬁlter Ignition systemCheck the safety system Main fuse Replacing the light bulbsFitting the cutting head When the engine is running. Mind your ﬁngersChecking the tyre pressure Checking the engine’s cooling air intakeTrapping your hand Removing the cutting unitAdjusting the parallelism of the cutting unit Checking the cutting unit’s parallelismReplacing the cutting unit belts Placing in the service position Service position for the cutting unitRestoring from service position Checking the bladesRemoving the BioClip plug Replacing the engine oil LubricationChecking the engine’s oil level Changing the oil ﬁlterLubricating the belt adjuster Checking the transmission oil levelGeneral lubrication Problem Procedure Troubleshooting scheduleGuard ServiceStorage Winter storageTechnical data EC-declaration of conformity Applies to Europe only Page ´z+S!r¶6H¨ Page 1151018-26 ´z+S!r¶6H¨ ´z+S!r¶6H¨