Husqvarna 15V2s AWD manual KEY to Symbols

Page 6

KEY TO SYMBOLS

Symbols

These symbols are on the machine and in the instructions.

WARNING! Careless or incorrect use can result in serious or fatal injury to the operator or others.

Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.

Always wear:

•Approved hearing protection

This product is in accordance with applicable EC directives.

Neutral

Fast

Slow

Stop the engine

Choke

Fuel

Oil level

Cutting height

Backwards

Forwards

6 – English

Ignition

Hydrostatic freewheel

Parking brake

Noise emission to the environment according to the European Community’s Directive. The machine’s emission is speciﬁed in chapter Technical data and on label.

Clutch in

Clutch out

Rotary blades Keep hands and feet away from under the hood when the engine is running

Risk that the machine will tip over

Never drive across a slope

Never use the machine if persons, especially children, or animals, are in the vicinity

Never carry passengers on the machine or equipment

Drive very slowly if no cutting unit is ﬁtted

Image 6

Contents Rider 15V2 Rider 15V2 AWD Rider 15V2s AWD EnglishContents Service journal Pre-delivery serviceAfter the ﬁrst 8 hours Driving and transport on public roads IntroductionDear Customer TowingGood service Serial NumberKEY to Symbols SymbolsBrake Starting instructions Insure your Rider Safety InstructionsSafety instructions General useDriving on slopes This is what you doMaintenance ChildrenTransport What is WHAT? Location of the controlsPresentation Lifting lever for the cutting unit Cutting height adjustment leverCutting unit LightsRelease lever Exercise care and refuel outdoors see safety instructionsFuelling Release lever Rider 15V2 AWDDriving Before startingStart the engine Driving the Rider Starting the engine with a weak batteryConnecting the jump leads Remove the cables in the reverse orderCutting tips Stop the engineOther objects which can be thrown out by the blades Maintenance Maintenance scheduleCleaning Checking and adjusting the steering wiresRemoving of the machine hoods Checking and adjusting of throttle wire Adjusting the parking brake RiderAdjusting the parking brake Rider 15V2 AWD Can result in reduced braking abilityReplacing the air ﬁlter Checking and adjusting the choke wireReplacement of fuel ﬁlter Cool before starting to replace the air ﬁlterIgnition system Check the level of the battery acid Dry-charged batteryChecking the fuel pump’s air ﬁlter Replacing the spark plugCheck the safety system Replacing the light bulbs Main fuseChecking the engine’s cooling air intake When the engine is running. Mind your ﬁngersChecking the tyre pressure Fitting the cutting headRemoving the cutting unit Trapping your handAdjusting the parallelism of the cutting unit Checking the cutting unit’s parallelismReplacing the cutting unit belts Service position for the cutting unit Placing in the service positionRestoring from service position Checking the bladesRemoving the BioClip plug Changing the oil ﬁlter LubricationChecking the engine’s oil level Replacing the engine oilLubricating the belt adjuster Checking the transmission oil levelGeneral lubrication Troubleshooting schedule Problem ProcedureWinter storage ServiceStorage GuardTechnical data EC-declaration of conformity Applies to Europe only Page ´z+S!r¶6H¨ Page 1151018-26 ´z+S!r¶6H¨ ´z+S!r¶6H¨