Pentair Hot Tub manual Plumbing Connections

Page 11

Installation (contd.)

10

 

 

 

 

 

TO

 

PUMP

 

 

 

POOL

 

 

POOL

 

MANUAL

 

FILTER

 

3

ISOLATION

 

 

HEATER

BY-PASS

 

 

VALVE

 

 

 

 

1 CHECK

 

 

 

 

 

VALVE

 

 

 

 

 

 

ISOLATION

 

 

 

 

 

VALVE

 

 

1 Optional.

 

 

 

VALVECHECK 2

 

2 Required when installation is below water level.

FROM

 

POOL

Figure 10.

3 Required when flow rates exceed 120 gpm.

 

PLUMBING CONNECTIONS

The MiniMax® CH heater has the unique capability of direct schedule 40 PVC plumbing connections.

CAUTION

Before operating the heater on a new installation, turn on the circulation pump and bleed all the air from the filter using the air relief valve on top of the filter. Water should flow freely through the heater.

Do not operate the heater unless water in the pool/ spa is at the proper level.

PLUMBING

VALVES

When any equipment is located below the surface of the pool or spa, valves should be placed in the circulation piping system to isolate the equipment from the pool or spa.

Check valves are recommended to prevent back siphon.

CAUTION

Exercise care when installing chemical feeders so as to not allow back siphoning of chemical into the heater, filters or pump. When chemical feeders are installed in the circulation of the piping system, make sure the feeder outlet line is down stream of the heater, and is equipped with a positive seal non-corrosive “Check Valve”, (P/N R172288), between the feeder and heater.

MANUAL BY-PASS

Where the flow rate exceeds the maximum 120 GPM, a manual bypass should be installed and adjusted. After adjustments are made, the valve handle should be removed to avoid tampering.

Model

Min.

Max. *

 

 

 

150

20

120

 

 

 

200

20

120

 

 

 

250

30

120

 

 

 

300

30

120

 

 

 

350

40

120

 

 

 

400

40

120

 

 

 

* Do not exceed the maximum recommended flow rate for the connecting piping.

Table 6.

BELOW POOL INSTALLATION

If the heater is below water level, the pressure switch should be adjusted. This adjustment must be done by a qualified service technician.

See following CAUTION.

CAUTION

BELOW OR ABOVE POOL INSTALLATION

The water pressure switch is set in the factory at 1½ PSI. This setting is for a heater installed at pool level or within 3’ above or 3’ below. If the heater is to be installed more that 3’ above or 3’ below, the water pressure switch must be adjusted by a qualified service technician.

FLOW SWITCH

If the heater is installed more the 6’ above the pool or more than 10’ below the pool level, you will be beyond the limits of the pressure switch and a flow switch must be installed. Locate and install the flow switch externally on the outlet piping from the heater, as close as possible to the heater. Connect the flow switch wires in place of the water pressure switch wires.

P/N 472128

Rev. E 11-5-07

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Pentair Water Pool and Spa, Inc. All rights reserved For additional free copies of this manual call 800 For Your Safety Read Before OperatingWhat to do if YOU Smell GAS Table of Contents Important Notices IntroductionCode Requirements Product Identification Warranty InformationSafety Rules OperationTo Turn OFF GAS to Heater For Your Safety Read Before LightingLighting Instructions Operating Controls Dual Temperature Control SystemSpring and Fall Operation MaintenanceMaintenance Instructions Energy Saving TipsPool and Spa Water PH ChartPH Control Chart Chemical BalanceOutdoor installation with vent kit Installation InstructionsSpecifications Outdoor installation stacklessPlumbing Plumbing ConnectionsReversible Inlet/Outlet Connection When Reversing Heads on the MiniMax CH HeaterWater Connections Insulating the High LimitsGAS Connections GAS Line InstallationsRegulated Manifold Pressure Test Stack Type Outdoor Vent KIT Outdoor Installation onlyOutdoor Vent CAP Installation VentilationFront All opening sizes are minimum and unobstructed Indoor Draft Hood InstallationStack Type Indoor Draft Hood KIT Electrical MiniMax CH Millivolt Wiring DiagramHeater Short Cycling Rapid On and Off Operation Troubleshooting GeneralHeater exchanger scaled Minimax CH Heater ALL Models MiniMax CH Parts List MiniMax CH Parts List, contd Rev. E MiniMax CH 150 IID Model Operation Operating InstructionsTo Turn OFF GAS to Appliance Safety Lockout Thermostat Knob Stopper Indicator Light DescriptionHeat Heat Troubleshooting ControlsTroubleshooting Controls Regulated Manifold Pressure Test InstallationTransformer Wiring Instruction Diagram Electronic Ignition WiringWire Remote Remote Switch Dual Therm IID onlyMinimax CH Heater 150 IID Model 150 MiniMax CH Parts List 150 IID ModelMiniMax CH Parts List 150 IID Model, contd Rev. E Pentair Water Pool and Spa, Inc. All rights reserved QUE Faire EN CAS D’ODEUR DE GAZ ? Chauffe Eau MiniMax CHTable des Matières Consignes IMPORTANTES… Exigences LégalesFonctionnement suite FonctionnementGarantie Consignes DE SécuritéFemer L’ARRIVÉE DU GAZ Vers L’APPAREIL Pour Votre Sécurité Lire Attentivement Avant D’ALLUMERConsignes DE Fonctionnement Commutateur Électrique Sélection du thermostat Fonctionnement ContrôlesFonctionnement EN Hiver Consignes DE MaintenanceFonctionnement EN Automne ET AU Printemps Tableau de contrôle du pH Équilibre ChimiqueEAU DE Piscine ET DE Thalasso Échelle de pHCaractéristiques Installation en extérieur sans cheminéeInstallation en extérieur avec kit de ventilation Déviation Manuelle Installation Sous LA PiscinePlomberie SoupapesInverser les Raccords d’Arrivée d’eau Raccords D’ARRIVÉE D’EAUIsoler LES Hautes Limites Branchement réversible entrée/sortieRaccord DE GAZ Installations DE LA Conduite DE GAZExigences Pour LA Pression DU GAZ DU Minimax CH Test PRÉ-RÉGLÉ DE Pression MultipleInstallation EN Extérieur Uniquement Côté Face Arrière Sommet Les exigences pour l’approvisionnement d’air ci Installation SUR DES Sols CombustiblesOrganigramme DES Circuits À Millivoltmètre DU Minimax CH Système ÉlectriqueDébit d’eau insuffisant Détection de pannes GénéralMettre en position on Chauffe-eau à cycle court Fonctionnement on et OFF rapideCHAUFFE-EAU Minimax CH Tout Modèle Liste des Pièces du MiniMax CH Sans Illustration Liste des Pièces du MiniMax CH suiteRemarques MiniMax CH 150 IID Model Fonctionnement Consignes DE FonctionnementFermer L’ARRIVÉE DU GAZ Vers L’APPAREIL Verrouillage de sécurité RemarqueCommutateur MARCHE/ARRÊT Sélecteur de température Description DES Voyants LumineuxPressostat Press Dépannage ContrôlesDépannage Contrôles Suite Raccordement Électrique Du Transformateur Vérification DE LA Pression ’ADMISSION ContrôléeÉLECTRIQUE, Unités Électroniques IID Classement électriqueSchéma de câblage du MiniMax CH Modèle 150 IID IIDCircuit DU Thermostat Commande À Distance À Deux FilsCHAUFFE-EAU Minimax CH Modèle 150 IID Description QTÉ Description QTÉ Remarques Conservez CES Consignes EN Lieu SÛR ¿QUÉ Hacer SI Huele a GAS? LEA Antes DE Operar POR SU SeguridadContenido Notas Importantes IntroducciónRequerimientos DE Códigos Operación contd OperaciónInformación DE Garantía Normas DE Seguridad¿CÓMO Desconectar EL GAS DEL CALENTADOR? LEA Antes DE Encender POR SU SeguridadInstrucciones DE Encendido Interruptor DE Energia Selector del termostato Operación ControlesOperaciones Durante Invierno MantenimientoOperaciones Durante LA Primavera Y Otoño Tabla 2. Cuadro de Control del pH Balance QuímicoAgua DE Piscinas Y SPA Cuadro pHInstalación Externa con kit de ventilación Instrucciones de InstalaciónEspecificaciones Instalacion Externa sin chimeneaVálvulas Conexiones Para LA TuberíaTuberías BY-PASS ManualAl Intercambiar los Cabezales del Calentador MiniMax CH Conexiones Para EL AguaAislamientodeloslímitesaltos Conexión intercambiable de entrada y salidaInstalaciones Lineales Para GAS Conexiones Para GASNatural Propano Prueba DE Presion DEL Colector ReguladoRequerimientos Para LA Presión DE GAS Minimax CH ¡IMPORTANTE VentilaciónSólo Instalación Externa KIT DE Ventilación Externa Tipo ChimeneaInstalación Para Protección Externa Canada Instalación Interna sólo para EeuuInstalación Interna DE LA Campana Lateral KIT DE Campana Lateral Interna Tipo ChimeneaElectrónica Diagrama de cableado electrónico millivoltVálvula de flujo defectuosa o no regulada Soluciónes para diferentes problemas GeneralCableado defectuoso Reemplazar o reparar Limpiar los filtros y coladores de la bombaCalentador Minimax CH- Todos LOS Modelos Lista DE Partes DEL Minimax CH Lista DE Partes DEL Minimax CH, contd Notas MiniMax CH 150 IID Modelo ¿Qué hacer cuando huele a gas? Instrucciones DE OperaciónCómo Desconectar EL GAS DEL Artefacto OperaciónCierre de seguridad Regulación DEL Termostato Descripción DE Luces IndicadorasCalor Heat Indicador DE Defectos ControlesIndicador DE Defectos Controles , Contd Instrucciones para el Cableado del Transformador Prueba DE Presión Múltiple ReguladaInstalación Redmv WHTPV/MV Blupv 150 IIDCables Remotos Interruptor Dual Remoto Termico IIDCalentador Minimax CH Modelo 150 IID ART Descripcion Cant Lista de partes del MiniMax CH Modelo 150 IIDART Descripcion Cant Calentador Minimax CH Modelo 150 IID, contdNotas Conserve Estas Instrucciones Pentair Water Pool and Spa, Inc. All rights reserved

Hot Tub specifications

Pentair has established itself as a prominent name in the hot tub industry, renowned for its commitment to innovation, quality, and user-friendly design. The Pentair Hot Tub brings together advanced features and cutting-edge technology, offering an unparalleled experience for relaxation and hydrotherapy.

One of the standout features of Pentair hot tubs is the emphasis on energy efficiency. Incorporating modern insulation techniques and energy-efficient pumps, these hot tubs minimize energy consumption while maximizing performance. This not only helps reduce utility bills but also benefits the environment, a priority for many eco-conscious consumers today.

The water filtration system in Pentair hot tubs is another notable characteristic. With state-of-the-art filtration technology, these hot tubs ensure crystal-clear water while requiring minimal maintenance. The system typically includes a combination of skimmers, cartridge filters, and ozonators, which work together to eliminate impurities and keep the water fresh, allowing users to spend more time enjoying their hot tub and less time on upkeep.

Comfort is paramount in Pentair hot tubs, which feature ergonomic seating and adjustable jets for a customized hydrotherapy experience. The strategically placed jets deliver targeted massage to key muscle groups, providing relief from stress and tension. Users can easily adjust the jet pressure to suit their preferences, making it suitable for everyone, from casual users to serious hydrotherapy aficionados.

Another significant technology integrated into the design of Pentair hot tubs is the advanced control system. This allows users to manage temperature, jet settings, lighting, and even integrated entertainment features such as Bluetooth audio systems via a user-friendly interface. With smart technology, users can also control their hot tub remotely, offering convenience and enhancing the overall user experience.

Durability and aesthetic appeal are also essential characteristics of Pentair hot tubs. Constructed with high-quality materials that resist fading, cracking, and warping, these hot tubs are designed to withstand various weather conditions while maintaining their beautiful appearance. The sleek design options and customizable colors allow users to choose a hot tub that complements their outdoor space beautifully.

In conclusion, Pentair hot tubs stand out for their combination of energy efficiency, advanced filtration systems, ergonomic comfort, smart technology, and durability, making them an excellent choice for anyone looking to invest in a quality hot tub experience. Whether for relaxation or therapeutic needs, the Pentair hot tub is designed to provide an exceptional outdoor oasis.
Top Page Image Contents