¨
ELECTRIC CHAIN SAW
CLEANING AND MAINTENANCE
Continued
Filing Cutter Depth Gauges
The cutter depth gauge clearance is reduced as cutters are sharpened. After every second or third sharpening, reset cutter depth gauges.
1.Place depth gauge tool firmly across top of two cutters. Make sure depth gauge enters slot in depth gauge tool (see Fig- ure 21).
2.Use medium flat file. File depth gauge level with depth gauge tool.
3.Remove depth gauge tool. With flat file, round off front corner of cutter depth gauge (see Figure 22).
Depth Gauge
Flat File
Depth
Gauge
Slot
Depth Gauge
Tool
Figure 21 - Depth Gauge Tool On Chain
Front Corner
Replacing Saw Chain
Replace chain when cutters are too worn to sharpen or when chain breaks. Only use re- placement chain noted in this manual. Al- ways include new drive sprocket when re- placing chain. This will maintain proper driving of chain. Note: For proper chain and drive sprocket, see Replacement Parts.
STORAGE
If storing saw for more than 30 days, fol- low steps below.
1.Drain oil tank.
2.Remove and clean guide bar and chain. Clean guide bar and chain by soaking in petroleum based solvent or mild soap and water mixture.
3.Dry guide bar and chain.
4.Place chain in container filled with oil. This will prevent rust.
5.Wipe a thin coating of oil over surface of guide bar.
6.Wipe off outside of saw body. Do this with soft cloth dampened with a mild soap and water mixture.
7.Store chain saw
•in a high or locked place, out of children’s reach
•in a dry place
•in a carrying case or with scabbard over guide bar
•with oil cap tight and saw upside down to prevent excess oil seepage
REPLACEMENT PARTS
WARNING: Use only replace- ment parts described in this manual. Use of other parts could damage saw or injure operator.
Purchase these parts from your local dealer.
Part
Number Description
091373S Chain, 30,5 cm (12")
091371S Chain, 25,4 cm (10")
LNT-2
104301S Chain, 20,3 cm (8")
*When ordering replacement Guide Bar
| PoleSaw |
|
| Guide bar, 20,3 cm (8") | |
| 104301S | Chain, 20,3 cm (8") |
| General |
|
Figure 22 - Round Off Front Corner Of | 075752 | Drive sprocket |
| Wrench/Screwdriver | |
Depth Gauge |
|
|
After several hand filings, have authorized service center or sharpening service machine sharpen chain. This will insure even filing.
For more information, visit www.desatech.com | 14 | 105020 |