Black & Decker LST220 Maintenance, Troubleshooting, Shown in figure, Replacing the Spool

Page 12

• Insert the 3/4 inch (19mm)

u

t

end of the bulk line into the

16

 

hole (t) in the spool

 

 

 

adjacent to the slot as

 

 

 

shown in figure 16.

 

 

 

• Wind the cutting line onto the spool in

17

the direction of the arrow on the spool.

 

Make sure to wind the line on neatlyand

 

in layers. Do not crisscross(figure 17).

 

• When the wound cutting line reaches

 

the recesses (u), cut the line. (figure 16).

 

• Fit the spool onto the tool as described

 

in “REPLACING THE SPOOL”.

 

THE RBRC™ SEAL

 

The RBRC™ (Rechargeable Battery Recycling

Corporation) Seal on the LI-ION battery (or battery pack)

indicates that the costs to recycle the battery (or battery

pack) at the end of its useful life have already been paid

RBRC™ in cooperation with Black & Decker and other battery users,

by Black & Decker.

 

has established programs in the United States to facilitate the

collection of spent LI-ION batteries. Help protect our environment and

conserve natural resources by returning the spent LI-ION battery to

an authorized Black & Decker service center or to your local retailer

for recycling. You may also contact your local recycling center for

information on where to drop off the spent battery. RBRC™ is a

registered trademark of the RechargeableBattery Recycling

Corporation.

MAINTENANCE

WARNING:

To avoid serious injury, remove the battery from

the tool before performing any maintenance.

1. Keep the air intake slots clean to avoid overheating.

2. Your trimmer line can dry out over time. To keep your line in top condition, store spare pre-wound spools or bulk line in a plastic, sealable bag with a tablespoon of water.

3. Plastic parts may be cleaned by using a mild soap and a damp rag.

4. The line cutter on the edge of the guard can dull over time. It is recommended you periodically touch-up the sharpness of the blade with a file.

IMPORTANT:To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by authorized service centers or other qualified service organizations, always using identical replacement parts.

TROUBLESHOOTING

TOOL RUNS SLOWLY

• Check that the spool housing can rotate freely. Carefully clean it if necessary.

• Check that the cutting line does not protrude more than approximately 5-3/8 inches (136mm) from the spool. If it does, cut it off so that it just reaches the line trimming blade.

AUTOMATIC LINE FEED DOES NOT WORK

• Keep the tabs depressed and remove the spool from the spool

12 housing in the trimmer head.

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Instructionmanual R KEY Information YOU should KnowTable of Contents Important Safety WarningsInstructions Avoid Dangerous Environmental Conditions Do Chemicals known to the State of California to cause cancerBirth defects or other reproductive harm. Some examples These chemicals areComponents For Battery Chargers For Battery Packs Read ALL InstructionsCharging Procedure Charger DiagnosticsBAD Battery HOT/COLD Pack DelayLeaving the Battery in the Charger Installing and Removing the Battery PackTo Install Battery Pack To Remove Battery PackAssembly & Adjustment Assembly Tools Required not SuppliedPhillips Screwdriver Attaching the Auxiliary HandleHeight Adjustment Switching on and OFFOperating Instructions Replacement Accessories Convert to Edging ModeCollar i as shown in part 1 Cutting Line / Line FeedingReplacing the Spool Figures 12,13,14 Tangled more frequently than Black & Decker factory woundSpools. For best results, factory wound spools are ReplacingMaintenance TroubleshootingShown in figure Replacing the SpoolService Information Full TWO-YEAR Home USE Warranty For Service & SalesSee ʻTools-Electricʼ Black & Decker U.S. IncMode DʼEMPLOI Voici DES Renseignements ImportantsLignes Directrices EN Matiere DE Securite Definitions Assemblage et réglageDomestique Servent à vous aider à reconnaître cette informationProtection endommagé, ou toute autre pièce endommagée, doit Être examiné soigneusement afin dʼassurer un fonctionnementNE PAS immerger lʼoutil dans lʼeau ou lʼarroser au boyau Éviter la pénétration de tout liquide dans lʼoutilComposants Importantes Pour LES Chargeurs DE Piles Adéquat AWG, American Wire Gauge calibrage américain Importantes Pour LES BLOCS-PILESRecommandations EN Matiere DE Rangement Lire Toutes LES DirectivesFonctions DE Diagnostic DU Chargeur Pile Laissee Dans LE ChargeurRemarques Importantes SUR LE Chargement Utilisation pour prolonger leur durée de vieInstallation DU BLOC-PILES DES RéglagesInsertion ET Retrait DU BLOC-PILES Retrait DU BLOC-PILESFixation DE LA Poignee Auxiliaire La figureReglage DE LA Hauteur Convertir AU Mode COUPE-BORDURE Mise EN Marche ET ArretMétallique j du boîtier du moteur de Accessoires DE Rechange FIL Tranchant / Avance DU FILRemplacer LA Bobine Section « Remplacer LA Bobine »LE Sceau Srprcmc Black & Decker.Black & DeckerCentral Ave Brockville Ontario K6V 5W6DE Litio DE 20 V MÁX Manual DE Instrucciones Importantes Sobre Seguridad Siempre Utilice Protección Para LOS Ojos utiliceUtilice LA Vestimenta Adecuada no utilice ropa holgada LA Cuerda Giratoria Realiza UNA Función DE CorteEsté Alerta fíjese en lo que está haciendo. Use el sentido La etiqueta de su herramienta puede incluir los siguientesSímbolos. Los símbolos y sus definicionesson los siguientes Revoluciones oComponentes InterruptorMargarita, tire del enchufe Baterías LEA Todas LAS InstruccionesNo incinere el paquete de baterías, aun si tiene daños Diagnostico DEL Cargador Procedimiento DE CargaBateria Danada Dejar EL Paquete DE Baterias EN EL CargadorENSAMBLADO/REGULACIONES Notas Importantes Sobre LA CargaQue se oiga un clic figura Destornillador PhillipsColocacion DEL Mango Auxiliar En la figuraEl logotipo de Black & 6 Decker hacia arriba Instrucciones DE Operacion Ajuste DE AlturaEncendido Y Apagado Accesorios DE Repuesto Conversión AL Modo DE BordeadoCuerda DE CORTE/ALIMENTACIÓNDE LA Cuerda Reemplazo DE Carretes Figuras 12,13,14 Enrollado DEL Carrete CON Cuerda a Granel UtiliceSolo Cuerda Redonda DE 1,7 MM 0,0065 Pulgada DE Reemplazo DEL CarreteInserte el extremo de la Cuerda a granel de 19 mm DEL Carrete EL Sello RbrcDeteccion DE Problemas LA Herramienta Funciona Lentamente LA Alimentacion Automatica DE LA Cuerda no FuncionaGarantia Completa DE DOS Anos Para USO EN EL Hogar Años DE GarantiaEsta Garantia no Aplica Cuando Name · Nombre Solamente Para Propositos DE Mexico
Related manuals
Manual 44 pages 52.53 Kb Manual 44 pages 31.47 Kb

LST220 specifications

The Black & Decker LST220R and LST220 are two innovative and powerful cordless string trimmers designed to make yard work easier and more efficient. These models cater to homeowners who want a flexible and lightweight solution for maintaining their lawns and gardens. Both trimmers share many features, making them reliable choices for tackling grass, weeds, and overgrown areas.

One of the standout features of the LST220R and LST220 is their 20-volt lithium-ion battery, which provides ample power and runtime needed for various trimming tasks. This battery technology ensures longer battery life and minimal self-discharge, allowing users to recharge and get back to work quickly. The trimmers come equipped with a 12-inch cutting swath, allowing for a wide trimming path that is efficient for medium to small-sized yards.

The innovative automatic feed spool system is another highlight, eliminating the hassle of manual line adjustments. This feature automatically feeds the cutting line as needed, ensuring a continuous, hassle-free operation while trimming. The dual-line design offers enhanced cutting performance, making it even easier to tackle tougher vegetation without compromising efficiency.

Ergonomics are a significant focus in the design of the LST220R and LST220. With their lightweight construction, these trimmers are easy to maneuver, reducing user fatigue during extended use. The adjustable height feature allows users to customize the trimmer's length, accommodating different user preferences and providing comfort while operating.

Moreover, both models come with the capability to convert from a trimmer to an edger, giving users greater versatility and functionality in one compact tool. The easy-to-use conversion feature allows for seamless switching between trimming and edging tasks, making it an excellent choice for those who want to ensure a neat and tidy lawn.

In summary, the Black & Decker LST220R and LST220 are excellent cordless trimmers that combine power, convenience, and versatility. With their efficient lithium-ion battery, automatic feed spool, lightweight design, and easy conversion to an edger, these trimmers make yard maintenance tasks less daunting. Homeowners can rely on these tools to keep their outdoor spaces looking pristine throughout the growing season.
Top Page Image Contents