Nilfisk-ALTO 5 SB FA operating instructions Vehicle Task Accessories Method

Page 16

NEPTUNE 5 SB FA

5.2Some typical cleaning tasks 5.2.1 Agriculture

Task

Accessories

Method

 

 

 

 

Stables

Chemical Foam Injec-

1.

Soaking – apply foam to all surfaces (bottom to top)

Pig Pens, Sties

tors

 

and wait for approx. 30 minutes.

 

Foam lance

2.

Remove the dirt from surfaces with the high pressure

Cleaning of walls,

Powerspeed lance

 

lance or chosen accessory. Again, clean from bottom

floors and equip-

Floor Cleaner

 

to top on vertical surfaces.

ment

Detergents

3.

To fl ush away large quantities of dirt, change to low

 

 

pressure mode and use the higher fl ow to push away

Disinfectant

Universal

 

the dirt.

 

Alkafoam

4.

Use recommended disinfectant products and methods

 

Disinfectant

 

to ensure hygiene. Apply DES 3000 disinfectant once

 

 

the surfaces are perfectly clean.

 

DES 3000

 

 

Machinery

Detergent injection

1.

Apply detergent to vehicle or equipment surfaces in

Tractors

Powerspeed lances

 

order to soften up dirt and grime. Apply from bottom

ploughs etc.

Curved lances and un-

 

to top.

 

derchassis washers

2.

Proceed with cleaning using the high pressure lance.

 

Brushes

 

Clean again from bottom to top. Use accessories to

 

 

 

clean in difficult to reach places.

 

 

3.

Clean fragile areas such as motors, rubber at lower

 

 

 

pressure levels to avoid damage.

 

 

 

 

5.2.2 Vehicle

 

 

 

Task

Accessories

Method

 

 

 

Vehicle bodywork

Standard lance

1. Apply detergent to vehicle or equipment surfaces in

 

Detergent injection

order to soften up dirt and grime. Apply from bottom

 

Curved lances and un-

to top. In cases of particularly dirty vehicles, pre-spray

 

derchassis washers

with a product such as Allosil in order to remove traces

 

brushes

of insects etc, then rinse at low pressure and apply

 

Detergents

normal car cleaning detergent. Let detergents settle

 

for 5 minutes before cleaning off. Metallic surfaces can

 

Active Shampoo

be cleaned using RimTop.

 

Active Foam

2. Proceed with cleaning using the high pressure lance.

 

Sapphire

Clean again from bottom to top. Use accessories to

 

Super Plus

clean in difficult to reach places. Use brushes in order

 

Aktive Wax

to add a mechanical cleaning effect. Short lances can

 

Allosil

help for cleaning of motors and wheel arches. Curved

 

RimTop

lances or undercarriage washers can be valuable for

 

 

the cleaning of car underchassis and wheel arches.

 

 

3. Clean fragile areas such as motors, rubber at lower

 

 

pressure levels to avoid damage.

 

 

4. Apply a liquid wax using the pressure washer in order

 

 

to protect the bodywork from pollution.

 

 

 

14

1) Options / model variants

Image 16
Contents Neptune 5 SB FA Neptune 5 SB FA Contents Important safety instructions Symbols used to mark instructionsFor your own safety GeneralWater connection LiquidOperation Testing DescriptionBypass valve PurposeTransport and assembly Before starting the cleanerSet the brake Antiscale Install Crank handle for high pressure hose reel/cord reelMachine flow L/h Pump size ml/h ˚dH Dosage Connecting the water supply Fill up fuel tankControl / Operation Mode Setting Self-service modeDaily tasks Switching off the cleaner Options / model variants Options / model variants Applications and methods Vehicle Task Accessories Method Buildings and Equipment Task Accessories Method After using the cleaner Storing the cleanerLines Below 0C 32FMaintenance Checking the pump oil quality Changing the pump oilEmptying the fuel oil TankTroubleshooting Indications on DisplayOther Faults Indication lights on control panelFurther information GuaranteeUS only EU Declaration of Conformity EU Declaration of ConformityInhalt Wichtige Sicherheitshinweise Kennzeichnung vonWarnung AllgemeinesWasseranschluss Schutzkleidung und Schutz- brille tragenBetrieb Beschreibung ElektrikWartung und Reparatur PrüfungVor der Inbetriebnahme BedienelementeTransport/Aufstellung Bremse einlegenKurbel für Schlauchtrommel und Kabeltrommel montieren Reinigungsmitteltanks füllenVorratsbehälter für Nilfisk-Alto AntiStone füllen Durchfluss l/h Pumpengröße ml/h ˚dH DosierungBrennstofftank füllen Wasserschlauch anschließenBedienung / Betrieb Elektrischer Anschluss AchtungFrostschutzmittel AuffangenBetriebsart SB-Betrieb/manuellen Betrieb einstellenSchalterstellung Oder Hinweis SB-Betrieb Tägliche KontrollenSpritzpistole verriegeln Dampfbetrieb über 100C Verwendung von ReinigungsmittelnAnwendungsgebiete und Arbeitsmethoden Temperatur MechanischeEinwirkung Und hoher DruckFahrzeuge Anwendung Zubehör Methode OberflächenBau und Industrie Anwendung Zubehör Methode Ober flächenNach der Arbeit StolpergefahrAufbewahrung Frostsichere LagerungWartung Wartungsplan Nach den ersten Alle 6 Monate Bei WöchentlichBetriebsstunden Bedarf Wartungsarbeiten 7.2.1 Wasserfilter reinigenPumpenölkontrolle PumpenölwechselBrennstofftank EntleerenBehebung von Störungen Anzeigen am DisplaySonstiges Garantie EG- Konformitätserklärung EG KonformitätserklärungTechnical Data NeptunePage Head Quarter