Craftsman MGP-769010 owner manual Operation, Checklist, Know Your High Pressure Washer

Page 7

7.Place assembled gun and wand on pressure washer holder.

8.Place pull cord into the wire bracket holder.Pull the cord under the wire bracket to the right of the wire loop. Lift the pull cord handle up and slide the cord to the left, sliding the cord into the wire loop. Next slide handle behind the wire bracket to the left of the wire loop. Engine recoil will pull the cord into its final position.

Checklist

Before going any further please review the following:

•Be sure you have completed assembly instructions.

•Double check all fittings to be sure they are tight.

IMPORTANT: Before any attempt to start your pres- sure washer be sure to check engine oil (See Opera- tion under Engine Oil.)

OPERATION

Know Your High Pressure Washer

Read this Owner’s Manual and Safety Rules before operation of your High Pressure Washer Compare this illustration with our pressure washer to familiarize yourself with the location of various con- trols and adjustments. Save this manual for future reference.

PUMP- Develops high pressure.

SPRAY GUN

ASSEMBLY

HIGH PRESSURE

HOSE

GAS TANK/CAP

HANDLE

RECOIL

STARTER

PRESSURE REGULATOR- Allows you to adjust the pressure of the outlet stream.

CHOKE

OIL FILL

ENGINE RUN/STOP SWITCH- Sets engine in starting mode for recoil starter — Stops running engine.

RECOIL STARTER- Used for starting the engine	ENGINE

manually.

STOP/START

SPRAY GUN ASSEMBLY (Contains Gun and Wand)- Controls the application of water onto cleaning surface with trigger device.

OIL FILL- Port where engine oil is poured.
GAS TANK/CAP- Cap is removed and unleaded	PRESSURE
gasoline is poured.	REGULATOR

CHEMICAL INJECTION TUBE AND FILTER- Mixes water and detergent in outlet water flow.

HIGH PRESSURE OUTLET- Connection for high pres- sure hose.

PUMP

CHOKE- Lever used for starting unit.

HIGH

WATER INLET

PRESSURE

OUTLET

CHEMICAL

INJECTOR

TUBE & FILTER

CONNECTION

7

Image 7

Contents Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A Operating InstructionsTable of Contents Damage Safety Guidelines DefinitionsImportant Safety Instructions Result in death or serious injuryRisk of Unsafe Operation Carton Contents AssemblyRemove Pressure Washer from Carton Tools Required for AssemblyPreparing the Pressure Washer for First Use Operation ChecklistKnow Your High Pressure Washer Gasoline Stopping Your Pressure WasherBefore Starting The Engine Engine OilTo Start Your Pressure Washer Using Soaps/Chemicals How To Use Your Pressure WasherGeneral Recommendations MaintenanceProduct Specifications Split BackupChanging Engine Oil Pressure Washer MaintenanceEngine Maintenance Check Oil Level Purge Pump of Air and ContaminantsNozzle Cleaning Service and AdjustmentsClean Pre-Cleaner and Air Cleaner Cartridge Clean and Replace Spark PlugPump Preparation StoragePreparing Pressure Washer for Storage Engine PreparationProblem Cause Correction TroubleshootingNo or low pressure after 900 PARTS/PARTESNot Included with Pressure Washer Pump PARTS/BOMBA Partes Parts Kits Briggs Engine Model #120602-01350-E2 Engine PARTS/MOTOR PartesEngine PARTS/MOTOR Partes Engine PARTS/MOTOR Partes Engine PARTS/MOTOR Partes Engine PARTS/MOTOR Partes Engine PARTS/MOTOR Partes Engine PARTS/MOTOR Partes Engine PARTS/MOTOR Partes Engine PARTS/MOTOR Partes Engine PARTS/MOTOR Partes Owner’s Warranty Responsibilities Briggs & Stratton Emission Control Defects Warranty CoverageImproper maintenance About your engine warrantyNormal wear Garantía Limitada DE DOS Años DEL Motor Craftsman Tabla DE ContenidosModeradas Pautas DE Seguridad DefinicionesInstrucciones Importantes DE Seguridad Causará la muerte o lesiones seriasRiesgo DE Operación Insegura Riesgo DE Lesiones Y EnsamblajeNota La manguera se encuentra en el fondo de la caja Herramientas Requeridas para el EnsamblajeSacar la Lavadora a Presión de la Caja Preparación de la Lavadora a Presión para el Primer UsoAntes de continuar, por favor comprobar lo siguiente OperaciónLista de Comprobación Familiarizarse con la Lavadora a PresiónGasolina Apagado de la Lavadora a PresiónAntes de Arrancar el Motor Aceite del MotorPara Arrancar la Lavadora a Presión Uso de Detergentes y Químicos Como usar la Lavadora a PresiónAro retén MantenimientoRecomendaciones Generales Purgar el aire y los contaminantes de la bombaMantenimiento del Motor Revisar el Nivel del Aceite Mantenimiento de la Lavadora a PresiónMantenimiento de la bomba Cambio del aceite de la bomba Purgar el Aire y los Contaminantes De la BombaLimpieza de la Boquilla Mantenimiento Y RegulacionesLimpiar y Reemplazar la Bujía CarburadorPreparación de la Bomba AlmacenamientoPreparación de la unidad para su Almacenamiento Preparación del MotorGuia DE Diagnosticos DE Problemas Nada o baja presión después Responsabilidades del propietario de la garantía Desgaste normal Acerca de la garantía de su motorNotas Notas Notas Get it fixed, at your home or ours