Risk of unsafe operation. If engine
does not start after two pulls, squeeze trigger of gun to relieve pump pressure. Pull starter cord slowly until resistance is felt. Then pull cord rapidly to avoid kickback and prevent hand or arm injury.
11.Depress trigger on gun to start water flow.
Risk of unsafe operation. Stand on
a stable surface and grip gun/spray wand firmly with both hands. Expect the gun to kick when triggered.
12.Release trigger to stop water flow.
Risk of injury from spray. Always
engage the trigger lock when gun is not in use. Failure to do so could cause accidental spraying.
Trigger Lock Engaged
13.Adjust nozzle spray for the task being performed. See How To Use Wand instructions in this section.
SHUTTING DOWN
1.After each use, if you have applied chemicals, place chemical hose into container of clean water and draw clean water through chemical injection system to rinse system thoroughly.
Risk of property damage. Failure
to do so could cause damage to the pump.
2.Turn engine off. See Engine Owner’s Manual.
Risk of property damage. NEVER
turn the water off with the engine running.
3.Turn water source off.
4.Pull trigger on spray gun to relieve any water pressure in hose or spray gun.
5.See Storage section in this manual for proper storage procedures.
A20116 | 14- ENG |