Zenoah RMSZ2601-CA, RMNBZ2601-CA manual If Someone Comes, Maintenance

Page 14

English

5. For safe operation

2.Keep sweeping attachment below waist level.

3.Maintain the speed of the engine at the level required to perform sweeping work, and never raise the speed of the engine above the level necessary.

4.If the unit start to shake or vibrate, turn off the engine and check the whole unit. Do not use it until the trouble has been properly corrected.

5.Keep all parts of your body away from rotating sweeping attachment and hot surfaces.

6.Never touch the muffler, spark plug, or other metallic parts of the engine while the engine is in operation or immediately after shutting down the engine. Doing so could result in serious burns or electrical shock.

• IF SOMEONE COMES

1.Guard against hazardous situations at all times. Warn adults to keep pets and children away from the area. Be careful if you are approached. Injury may result from flying debris.

2.If someone calls out or otherwise interrupts you while working, always be sure to turn off the engine before turning around.

■MAINTENANCE

1.In order to maintain your product in proper working order, perform the maintenance and checking operations described in the manual at regular intervals.

2.Always be sure to turn off the engine before performing any maintenance or checking procedures.

(1) Check ok !

WARNING

The metallic parts reach high temperatures immediately after stopping the engine.

3.When replacing the sweeping attachment or any other part, or when replacing the oil or any lubricant, always be sure to use only RedMax products or products which have been certified by RedMax for use with the RedMax product.

4.In the event that any part must be replaced or any maintenance or repair work not described in this manual must be performed, please contact a representative from the store nearest RedMax authorized servicing dealer for assistance.

5.Do not use any accessory or attachment other than those bearing the RedMax mark and recommended

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents OWNER/OPERATOR Manual Mode D’EMPLOI Manual DE Instrucciones Contents Advertencias Contenidas EN EL Manual Differents Types D’AVERTISSEMENT DE CE Mode D’EMPLOITables des matieres Contenido RMSZ2601 / RMNBZ2601 / RMSZ2601-CA / RMNBZ2601-CA SpecificationsParts location Especificaciohes Emplacement des pieces Situación de las piezasFiche technique Wear head, eye and ear protection Symbols on the machineMachine PositionEmplacement PosiciónWorking Circumstance For safe operationWorking Condition Condiciones DE Trabajo Consignes de securite Instrucciones de seguridadConditions DE Travail PrecaucionesWorking Plan Before Starting the EngineDE LA Machine Plan DE TravailPlan DE Trabajo Avant DE Mettre LE Moteur EN MarcheUse only for tasks explained in the manual Using the ProductStarting the Engine Utilisation DE LA Machine Demarrage DU MoteurArranque DEL Motor USO DEL ProductoMaintenance If Someone ComesSI Alguien SE Aproxima SI QUELQU’UN S’APPROCHEEntretien MantenimientoTransportation Handling FuelRefill after cooling the engine Manipulación DEL Combustible Manipulation DU CarburantTransport TransporteSweeper Assembly SE2 Set upInstall the Handle Clevis Pin Hitch Pin Cotter Pin Drum Axle Drum AssemblyConjunto DE LA Barredora SE2 Assemblage MontajeEnsemble DE Balayage SE2 Nylon Brush Attachment Procedure SE3Assemblage Montaje Set up Procédure d’installation Procedimiento de instalación Recommended Mixing Ratio Gasoline 50OIL When using RedMax/ZENOAH genuine oilFuel Lors de l’utilisation de la véritable huile RedMax/ZENOAH Rapport DE Melange Recommande Essence 50 HuileCarburant Combustible Proporción DE LA Mezcla Recomendada Gasolina 50 AceiteFor Your Engine LIFE, Avoid HOW to MIX FuelFueling the Unit Eviter Pour Prolonger LA Duree DE VIE DU Moteur Comment Obtenir UN BON Melange Como Mezclar EL CombustibleRemplissage DU Reservoir Abastecimiento DE LA UnidadFuel Combustible SIN Aceite Gasolina Cruda Sweeping head will start rotating upon the engine starts OperationOP1 OP2 OP3 OP4 Starting Engine Fonctionnement Uso OP5 Adjusting Throttle CableAdjusting Idling Speed OP6 OP6 OP7 Stopping Engine OP3Reglage DU Ralenti OP6 Reglage Câble D’ACCÉLÉRATEURAjuste Cable DEL Acelerador Avant DE Commencer L’UTILISATIONOP8 OP9 Direction of rotationDirección de giro Sens de rotationTécnicas DE Funcionamiento OP8 OP9 OP10 Maintain a shallow angle to the work surface Operating and Safety Tips OP11OP10 OP11 YOU Must Always Guard Against Thrown DebrisConsejos DE Funcionamiento Y Seguridad OP11 Fonctionnement UsoConseils D’UTILISATION ET DE Securite OP11 Vous Devez Toujours Vous Proteger DES Debris ProjetesAvoid low rpm operation General Safety InstructionsNever make unauthorized attachment installations Stay Alert Work SafelyInstructions Generales DE Securite Instrucciones Generales DE SeguridadMaintenance Maintenance ChartTableau D’ENTRETIEN EntretienMantenimiento Tabla DE MantenimientoReplacing the Gearcase OIL MA1 MA1Gearcase Lubrication End cap Main gearEntretien Mantenimiento Remplacement DE L’HUILE DU Carter ’ENGRENAGE MA1Cambio DEL Aceite DE LA Caja DE Cambios MA1 Capot de carter Engrenage principalAIR Filter Replacement Plug is a NGK CMR7HMA2 MA3 MA4 Fuel FilterBougie D’ALLUMAGE Filtre a AIRFiltre a Carburant Filtro DE AireSpark Arrester Tightening TorqueMuffler MA5 MA6 Intake AIR Cooling VentSilencieux Silenciador Couple DE SerragePAR DE Torsión PARE-ETINCELLESDisposal Procedures to be Performed After Every 100 Hours of USEStorage MA7Mise au rebut Eliminación Procedure a Effectuer Toutes LES 100 Heures D’UTILISATIONRangement Almacenamiento Cilindro Toma de aire de refrigeración posteriorGuide de localisation des pannes Troubleshooting guide12. Guía de localización y solución de problemas Barredora NotaRMSZ2601 / RMSZ2601-CA Pipe Comp RMNBZ2601 / RMNBZ2601-CA Nylon Brush Ass’y 99909-11004 Parts list Description Part Number Qty Manufacturer’s warranty coverage Owner’s warranty responsibilitiesCouverture de la garantie constructeur Obligations du propriétaire liées à la garantieCobertura de la garantía dada por el fabricante Responsabilidades del propietarioLimited Warranty Garantie limitée Garantía Limitada Control DE Emisiones Emission Control Mesures DE Lutte ContreLES Emissions RMSZ2601-CA/RMNBZ2601-CA RMSZ2601-CA/RMNBZ2601-CA

RMSZ2601-CA, RMNBZ2601-CA, RMNBZ2601, RMSZ2601 specifications

The Zenoah RMSZ2601, RMNBZ2601, RMNBZ2601-CA, and RMSZ2601-CA are advanced, high-performance engines designed for professional use in various applications, particularly in the realms of landscaping, agriculture, and industrial equipment. Known for their reliability and durability, these engines are engineered to meet the rigorous demands of both commercial and residential users.

One of the standout features of these models is their two-stroke engine design, which allows for a higher power-to-weight ratio compared to four-stroke engines. This lightweight construction makes the Zenoah engines easier to maneuver and operate in tight spaces without sacrificing power. The RMSZ2601, for instance, boasts a displacement of 26 cc, delivering impressive torque and efficiency, making it suitable for a range of tasks from trimming to industrial drives.

Another key characteristic of these engines is their advanced ignition system, which enhances starting ease and operational stability. The incorporation of Zenoah’s unique digital ignition technology ensures a quick start and consistent performance across varying conditions. Additionally, these engines are equipped with an anti-vibration system that minimizes operator fatigue, enabling extended use without discomfort.

The RMNBZ2601 and its variants are also designed with an emphasis on reduced emissions. The CA models incorporate catalytic converters to meet stringent environmental regulations, making them a responsible choice for users conscious of their ecological footprint. This not only helps comply with governmental standards but also contributes to a cleaner working environment.

Moreover, Zenoah emphasizes user-friendly features in their engine designs. Both the RMSZ2601 and RMNBZ2601 models feature easy-access fuel and oil tanks that simplify refueling and maintenance. The filters are conveniently positioned for straightforward cleaning and replacement, ensuring longer operational life and reliability.

Durability is a hallmark of the Zenoah brand. The engines are constructed with high-grade materials that withstand the rigors of heavy-duty use. This ensures that the RMSZ2601, RMNBZ2601, and their variants maintain peak performance over time, even under challenging operating conditions.

In summary, the Zenoah RMSZ2601, RMNBZ2601, RMNBZ2601-CA, and RMSZ2601-CA represent cutting-edge technology in the small engine market, delivering robust performance, low emissions, and reliability. These features make them ideal choices for professionals in landscaping, agriculture, and other demanding sectors.
Top Page Image Contents