Husqvarna crt51 instruction manual Install handle

2.Assembly 2. Zusammenbau

2.Montage 2. Montaje

2.Montaggio 2. Montering

Eng 1. Gearcase notch

2.Handle lock

3.Handle (high position)

4.Shift lever

5.Handle (low position)

6.Handle lock lever

Figure 1

1

2

Figure 2

3 4

6

5

Install handle

a.Insert one handle lock (with teeth facing outward) in gearcase notch (fig. 1). Apply grease on smooth side of handle lock. This will aid in keeping lock in place until handle is lowered into postion.

b.Grasp handle assembly, ease handle base into "up" position as shown in figure 2. Be sure handle lock remains in gearcase notch. Be careful not to stretch or kink cables.

c.Rotate handle assembly down. Insert rear carriage bolt (fig. 3-inset) first, with head of bolt on L.H. side of tiller. Insert front pivot bolt. Lower the handle assembly. Tighten bolts so handle moves with some resistance.

d.Insert second handle lock (with teeth facing inward) in slot handle base (fig. 3-inset).

e.Place washer on threaded end of handle lock lever.

f.Insert handle lock lever through handle base and gear case (fig. 3-inset).

g.With handle assembly in lowest position, securely tighten handle lock lever by rotating clockwise.

7