Genie GS-3268, GS-2668 DC manual Maintenance, Observe and Obey, Check the Hydraulic Oil Level

Page 15

Third Edition • Third Printing

Operator's Manual

 

 

 

 

 

 

Maintenance

Observe and Obey:

Only routine maintenance items specified in this manual shall be performed by the operator.

Scheduled maintenance inspections shall be completed by qualified service technicians, according to the manufacturer's specifications and the requirements specified in the responsibilities manual.

Maintenance Symbols Legend

The following symbols have been used in this manual to help communicate the intent of the instructions. When one or more of the symbols appear at the beginning of a maintenance procedure, it conveys the meaning below.

Indicates that tools will be required to perform this procedure.

Indicates that new parts will be required to perform this procedure.

Check the Hydraulic Oil Level

Maintaining the hydraulic oil at the proper level is essential to machine operation. Improper hydraulic oil levels can damage hydraulic components. Daily checks allow the inspector to identify changes in oil level that might indicate the presence of hydraulic system problems.

Perform this procedure with the platform in the stowed position.

1Visually inspect the sight gauge located on the side of the hydraulic tank.

Result: The hydraulic oil level should be within the top 2 inches / 5 cm of the sight gauge.

2 Add oil if necessary. Do not overfill.

Hydraulic oil specifications

Hydraulic oil type

Chevron Rykon

 

Premium MV equivalent

 

 

Part No. 82750

Genie GS-2668 DC and Genie GS-3268 DC

13

Image 15
Contents Operator’s Manual Contact us ContentsDo Not Operate Unless Safety RulesTip-over Hazards Electrocution HazardsGS-2668 DC Fall Hazards Collision Hazards Bodily Injury HazardComponent Damage Hazards Decal Legend Explosion and Fire HazardsDamaged Machine Hazards Crushing HazardsTip-over Hazard Battery Safety Burn HazardsExplosion Hazards Component Damage HazardPage Platform Controls ControlsGround Control Panel StopFundamentals Pre-operation InspectionPre-operation Inspection Check the Hydraulic Oil Level MaintenanceMaintenance Symbols Legend Observe and ObeyCheck the Batteries Scheduled MaintenanceFunction Tests Test the Auxiliary Lowering At the Ground ControlsTest the Emergency Stop Test the Up/Down FunctionsTest the Horn Test the Function Enable SwitchAt the Platform Controls Test Emergency StopTest Drive and Braking Test the SteeringTest the Tilt Sensor Operation Test Limited Drive SpeedWorkplace Inspection Workplace InspectionOperating Instructions Emergency StopOnly use the machine as it was intended Auxiliary Lowering Operation From GroundOperation From Platform Fall Protection Drive Select SwitchError Indicator Light On Operation From Ground with ControllerBattery and Charger Instructions Observe and Obey To Charge BatteryDry Battery Filling Charging Instructions Brake Release Operation Transport and Lifting InstructionsAxis Lifting InstructionsSecuring to Truck or Trailer for Transit Inspection for Decals with Words DecalsDecals Ground Controls Side Battery SideInspection for Decals with Symbols Battery Side Ground Controls D e l GS-2668 DC SpecificationsSpecifications Distributed By