Genie GS-2668 DC, GS-3268 manual Lifting Instructions, Axis

Page 28

Operator's Manual

Third Edition • Third Printing

 

 

 

 

 

 

TRANSPORT AND LIFTING INSTRUCTIONS

Observe and Obey:

Only qualified riggers should rig and lift the machine.

Be sure the crane capacity, loading surfaces and straps or lines are sufficient to withstand the machine weight. See the serial plate for the machine weight.

Lifting Instructions

Fully lower the platform. Be sure the extension deck, controls and covers are secure. Remove all loose items on the machine.

Determine the center of gravity of your machine using the table and the picture on this page.

Attach the rigging only to the designated lifting points on the machine. There are two lifting points on each end of the machine.

Adjust the rigging to prevent damage to the machine and to keep the machine level.

Y Axis

Center of gravity

X Axis

Y Axis

 

 

 

 

 

GS-2668 DC

34.4

in

25.8

in

 

87.4 cm

65.5 cm

 

 

 

 

 

GS-3268 DC

33.3

in

27.3

in

 

84.6 cm

69.3 cm

 

 

 

 

 

X Axis

26

Genie GS-2668 DC and Genie GS-3268 DC

Part No. 82750

Image 28
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsGS-2668 DC Fall Hazards Bodily Injury Hazard Collision HazardsComponent Damage Hazards Explosion and Fire Hazards Damaged Machine HazardsCrushing Hazards Decal LegendBattery Safety Burn Hazards Explosion HazardsComponent Damage Hazard Tip-over HazardPage Controls Platform ControlsStop Ground Control PanelPre-operation Inspection FundamentalsPre-operation Inspection Maintenance Maintenance Symbols LegendObserve and Obey Check the Hydraulic Oil LevelScheduled Maintenance Check the BatteriesFunction Tests At the Ground Controls Test the Emergency StopTest the Up/Down Functions Test the Auxiliary LoweringTest the Function Enable Switch At the Platform ControlsTest Emergency Stop Test the HornTest the Steering Test Drive and BrakingTest Limited Drive Speed Test the Tilt Sensor OperationWorkplace Inspection Workplace InspectionEmergency Stop Operating InstructionsOnly use the machine as it was intended Operation From Ground Auxiliary LoweringOperation From Platform Drive Select Switch Error Indicator Light OnOperation From Ground with Controller Fall ProtectionTo Charge Battery Battery and Charger Instructions Observe and ObeyDry Battery Filling Charging Instructions Transport and Lifting Instructions Brake Release OperationLifting Instructions AxisSecuring to Truck or Trailer for Transit Decals Inspection for Decals with WordsGround Controls Side Battery Side DecalsInspection for Decals with Symbols Battery Side Ground Controls Specifications D e l GS-2668 DCSpecifications Distributed By