Genie GS-2668 DC, GS-3268 Battery and Charger Instructions Observe and Obey, To Charge Battery

Page 26

Operator's Manual

Third Edition • Third Printing

 

 

 

 

 

 

OPERATING INSTRUCTIONS

Battery and Charger Instructions

Observe and Obey:

Do not use an external charger or booster battery.

Charge the battery in a well-ventilated area.

Use proper AC input voltage for charging as indicated on the charger.

Use only a Genie authorized battery and charger.

To Charge Battery

1Be sure the batteries are connected before charging the batteries.

2Open the battery compartment. The compartment should remain open for the entire charging cycle.

3Remove the battery vent caps and check the battery acid level. If necessary, add only enough distilled water to cover the plates. Do not overfill prior to the charge cycle.

4Replace the battery vent caps.

5Connect the battery charger to a grounded AC circuit.

6The charger will indicate when the battery is fully charged.

7Check the battery acid level when the charging cycle is complete. Replenish with distilled water to the bottom of the fill tube. Do not overfill.

Dry Battery Filling and

Charging Instructions

1Remove the battery vent caps and permanently remove the plastic seal from the battery vent openings.

2Fill each cell with battery acid (electrolyte) until the level is sufficient to cover the plates.

Do not fill to maximum level until the battery charge cycle is complete. Overfilling can cause the battery acid to overflow during charging. Neutralize battery acid spills with baking soda and water.

3Install the battery vent caps.

4Charge the battery.

5Check the battery acid level when the charging cycle is complete. Replenish with distilled water to the bottom of the fill tube. Do not overfill.

24

Genie GS-2668 DC and Genie GS-3268 DC

Part No. 82750

Image 26
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsGS-2668 DC Fall Hazards Component Damage Hazards Collision HazardsBodily Injury Hazard Crushing Hazards Explosion and Fire HazardsDamaged Machine Hazards Decal LegendComponent Damage Hazard Battery Safety Burn HazardsExplosion Hazards Tip-over HazardPage Controls Platform ControlsStop Ground Control PanelPre-operation Inspection FundamentalsPre-operation Inspection Observe and Obey MaintenanceMaintenance Symbols Legend Check the Hydraulic Oil LevelScheduled Maintenance Check the BatteriesFunction Tests Test the Up/Down Functions At the Ground ControlsTest the Emergency Stop Test the Auxiliary LoweringTest Emergency Stop Test the Function Enable SwitchAt the Platform Controls Test the HornTest the Steering Test Drive and BrakingTest Limited Drive Speed Test the Tilt Sensor OperationWorkplace Inspection Workplace InspectionOnly use the machine as it was intended Operating InstructionsEmergency Stop Operation From Platform Auxiliary LoweringOperation From Ground Operation From Ground with Controller Drive Select SwitchError Indicator Light On Fall ProtectionDry Battery Filling Charging Instructions Battery and Charger Instructions Observe and ObeyTo Charge Battery Transport and Lifting Instructions Brake Release OperationLifting Instructions AxisSecuring to Truck or Trailer for Transit Decals Inspection for Decals with WordsGround Controls Side Battery Side DecalsInspection for Decals with Symbols Battery Side Ground Controls Specifications D e l GS-2668 DCSpecifications Distributed By