Genie GS-2668 DC, GS-3268 manual Pre-operation Inspection

Page 14

Operator's Manual

Third Edition • Third Printing

 

 

 

 

 

 

PRE-OPERATION INSPECTION

Pre-operation Inspection

oBe sure that the operator's, safety and responsibilities manuals are complete, legible and in the storage container located on the platform.

oBe sure that all decals are legible and in place. See Decals section.

oCheck for hydraulic oil leaks and proper oil level. Add oil if needed. See Maintenance section.

oCheck for battery fluid leaks and proper fluid level. Add distilled water if needed. See Maintenance section.

Check the following components or areas for damage, improperly installed or missing parts and unauthorized modifications:

oElectrical components, wiring and electrical cables

oHydraulic power unit, tank, hoses, fittings, cylinders and manifolds

oBattery pack and connections

oDrive motors

oWear pads

oTires and wheels

oLimit switches, alarms and horn

oNuts, bolts and other fasteners

oPlatform entry gate

oBeacon and alarms (if equipped)

oBrake release components

oSafety arm

oPlatform extension

oScissor pins and retaining fasteners

oPlatform control joystick

oInverter (if equipped)

Check entire machine for:

oCracks in welds or structural components

oDents or damage to machine

oBe sure that all structural and other critical components are present and all associated fasteners and pins are in place and properly tightened.

oBe sure side rails are installed and snap pins and bolts are fastened

oBe sure that the chassis trays are in place, latched and properly connected.

12

Genie GS-2668 DC and Genie GS-3268 DC

Part No. 82750

Image 14
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsGS-2668 DC Fall Hazards Component Damage Hazards Collision HazardsBodily Injury Hazard Crushing Hazards Explosion and Fire HazardsDamaged Machine Hazards Decal LegendComponent Damage Hazard Battery Safety Burn HazardsExplosion Hazards Tip-over HazardPage Controls Platform ControlsStop Ground Control PanelPre-operation Inspection FundamentalsPre-operation Inspection Observe and Obey MaintenanceMaintenance Symbols Legend Check the Hydraulic Oil LevelScheduled Maintenance Check the BatteriesFunction Tests Test the Up/Down Functions At the Ground ControlsTest the Emergency Stop Test the Auxiliary LoweringTest Emergency Stop Test the Function Enable SwitchAt the Platform Controls Test the HornTest the Steering Test Drive and BrakingTest Limited Drive Speed Test the Tilt Sensor OperationWorkplace Inspection Workplace InspectionOnly use the machine as it was intended Operating InstructionsEmergency Stop Operation From Platform Auxiliary LoweringOperation From Ground Operation From Ground with Controller Drive Select SwitchError Indicator Light On Fall ProtectionDry Battery Filling Charging Instructions Battery and Charger Instructions Observe and ObeyTo Charge Battery Transport and Lifting Instructions Brake Release OperationLifting Instructions AxisSecuring to Truck or Trailer for Transit Decals Inspection for Decals with WordsGround Controls Side Battery Side DecalsInspection for Decals with Symbols Battery Side Ground Controls Specifications D e l GS-2668 DCSpecifications Distributed By