Briggs & Stratton 209443gs manual Troubleshooting

Page 19

Troubleshooting

	Problem	Cause		Correction

		1.	One of the circuit breakers is open.	1.	Reset circuit breaker.
	Engine is running, but no AC	2.	Fault in generator.	2.	Contact authorized service facility.
	Engine is running, but no AC	3.	Poor connection or defective cord set.	3.	Check and repair.
	output is available.	3.	Poor connection or defective cord set.	3.	Check and repair.
	output is available.	4.	Connected device is bad.	4.	Connect another device that is in good
		4.	Connected device is bad.	4.	Connect another device that is in good
					condition.

		1.	Short circuit in a connected load.	1.	Disconnect shorted electrical load.
	Engine runs good at no-load but	2.	Engine speed is too slow.	2.	Contact authorized service facility.
	“bogs down” when loads are	3.	Generator is overloaded.	3.	See Don’t Overload Generator in
	connected.				Operation section.
		4.	Shorted generator circuit.	4.	Contact authorized service facility.

		1.	Rocker switch set to “Off”.	1.	Set switch to “On”.
		2.	Fuel Valve is in “Off” position.	2.	Turn fuel valve to “Open” position.
		3.	Dirty air cleaner.	3.	Clean or replace air cleaner.
		4.	Out of fuel.	4.	Fill fuel tank.
		5.	Stale fuel.	5.	Drain fuel tank and carburetor; fill with
					fresh fuel.
	Engine will not start; or starts	6.	Spark plug wire not connected to spark	6.	Connect wire to spark plug.
	Engine will not start; or starts		plug.
	and runs rough.		plug.
	and runs rough.	7.	Bad spark plug.	7.	Replace spark plug.
		7.	Bad spark plug.	7.	Replace spark plug.
		8.	Water in fuel.	8.	Drain gas tank and carburetor; fill with
					fresh fuel.
		9.	Flooded.	9.	Wait 5 minutes and re-crank engine.
		10.	Excessively rich fuel mixture.	10.	Contact authorized service facility.
		11.	Intake valve stuck open or closed.	11.	Contact authorized service facility.
		12.	Engine has lost compression.	12.	Contact authorized service facility.

	Engine shuts down when	Out of fuel.		Fill fuel tank.
	running.

		1.	Load is too high.	1.	See Don’t Overload Generator in
	Engine lacks power.				Operation section.
		2.	Dirty air filter.	2.	Replace air filter.

	Engine “hunts” or falters.	Carburetor is running too rich or too lean.		Contact authorized service facility.

19

Image 19

Contents Operator’s Manual Date Purchased Where to Find UsGenerator EngineTable of Contents Equipment Description Operator SafetyImportant Safety Information Safety Symbols and MeaningsWhen Transporting or Repairing Equipment When Adding or Draining FuelWhen Starting Equipment When Operating EquipmentExcessively low speeds impose a heavy load When Testing for Engine SparkUnpack Generator AssemblyInstall Wheel Kit Install the wheel kit as followsFuel must meet these requirements When Adding FuelAdd Engine Oil Add FuelSpecial Requirements Connecting to a Building’s Electrical SystemSystem Ground Generator LocationItems Not Shown Features and ControlsVolt AC, 20 Amp, Duplex Receptacle Cord Sets and ReceptaclesNema L14-20 120/240 Volt AC, 20 Amp, Locking ReceptacleStarting the Engine OperationStopping the Engine Connecting Electrical LoadsWarm Weather Operation Wattage Reference Guide Don’t Overload GeneratorFuel Valve Maintenance MaintenanceMaintenance Schedule Generator MaintenanceOil Engine MaintenanceInspect Muffler and Spark Arrester Service Air CleanerService Spark Plug Clean and inspect the spark arrester as followsStorage Troubleshooting Briggs & Stratton Emissions Control Warranty Provisions Your Warranty Rights And ObligationsManufacturer’s Warranty Coverage Owner’s Warranty ResponsibilitiesIntermediate ModerateExtended Limited Warranty Reserved Common Service Parts Product Specifications800 Manual del Operario Fecha de compra Dónde encontrarnosGenerador MotorControles y características Resolución de problemas GarantíasSeguridad de operario MontajeSímbolos sobre la seguridad y significados Seguridad de operarioDescripción del equipo Información importante de seguridadCuando Transporte O Repare EL Equipo Cuando Anada Combustible O Vacíe EL DepósitoCuando Ponga EN Funcionamiento EL Equipo Cuando Opere EL EquipoCuando Pruebe LA Bujía DEL Motor Cuando Ajuste O Haga Reparaciones a SU Máquina GeneradorEl generador se entrega con MontajeDesembalaje del generador Instale el juego de ruedasGran altitud Agregar aceite al motorAgregue combustible El combustible debe reunir los siguientes requisitosRequisitos especiales Tierra del sistemaConexión al sistema eléctrico de un edificio Ubicación del generadorNo mostrado Controles y característicasDispositivo de seguridad de 120/240 V, 20 a Juegos de cordones y enchufes conectoresTomas eléctricas dobles de 120 V CA y 20 a Encienda el motor OperandoParada del motor Conexión de cargas eléctricasFuncionamiento en clima cálido Control de la energía No sobrecargar el generadorCapacidad EjemploPlan de mantenimiento MantenimientoMantenimiento del generador Comprobación del nivel de aceite Mantenimiento de la válvula de combustibleMantenimiento del motor Aceite Recomendaciones sobre el aceiteServicio del depurador de aire Cambio de aceite del motorServicio del bujía Ajuste del carburador Inspeccione el silenciador y la pantalla apagachispasLimpie e inspeccione el apagachispas de la siguiente manera Sistema de refrigeración de aireCambio de aceite AlmacenamientoGenerador Almacenamiento para periodos prolongadosProblemo Causa Accion Resolución de problemasResponsabilidades de la garantía del propietario GarantíasDerechos y obligaciones de la garantía Cobertura de la garantía del fabricanteBRIGGSandSTRATTON.COM Garantía Limitada Servicio común despide Especificaciones del producto