Briggs & Stratton 209443gs manual Warranties, Your Warranty Rights And Obligations

Page 20

Warranties

California, U.S. EPA, and Briggs & Stratton

Corporation Emissions Control Warranty

Statement

Your Warranty Rights And Obligations

The California Air Resources Board, U.S. EPA, and Briggs & Stratton (B&S) are pleased to explain the emissions control system warranty on your Model Year 2008 and later engine/equipment. In California, new small off-road engines must be designed, built, and equipped to meet the State’s stringent anti-smog standards. B&S must warrant the emissions control system on your engine/equipment for the periods of time listed below provided there has been no abuse, neglect, or improper maintenance of your small off- road engine.

Your emissions control system may include parts such as the carburetor or fuel injection system, fuel tank, ignition system, and catalytic converter. Also included may be hoses, belts, connectors, sensors, and other emissions-related assemblies. Where a warrantable condition exists, B&S will repair your engine/equipment at no cost to you including diagnosis, parts, and labor.

Manufacturer’s Warranty Coverage:

Small off-road engines are warranted for two years. If any emissions-related part on your engine/equipment is defective, the part will be repaired or replaced by B&S.

Owner’s Warranty Responsibilities:

As the small engine/equipment owner, you are responsible for the performance of the required maintenance listed in your owner’s manual. B&S recommends that you retain all receipts covering maintenance on your engine/equipment, but B&S cannot deny warranty solely for the lack of receipts or your failure to ensure the performance of all scheduled maintenance.

As the engine/equipment owner, you should however be aware that B&S may deny you warranty coverage if your engine/equipment or a part has failed due to abuse, neglect, improper maintenance, or unapproved modifications.

You are responsible for presenting your engine/equipment to a B&S distribution center, servicing dealer, or other equivalent entity, as applicable, as soon as a problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days. If you have any questions regarding your warranty rights and responsibilities, you should contact B&S at (414) 259-5262.

Briggs & Stratton Emissions Control Warranty Provisions

The following are specific provisions relative to your Emissions Control Warranty Coverage. It is in addition to the B&S engine warranty for non-regulated engines found in the Operator’s Manual.

1.Warranted Emissions Parts

Coverage under this warranty extends only to the parts listed below (the emissions control systems parts) to the extent these parts were present on the engine purchased.

a.Fuel Metering System

Cold start enrichment system (soft choke)

Carburetor and internal parts

Fuel pump

Fuel line, fuel line fittings, clamps

Fuel tank, cap and tether

Carbon canister

b.Air Induction System

Air cleaner

Intake manifold

Purge and vent line

c.Ignition System

Spark plug(s)

Magneto ignition system

d.Catalyst System

Catalytic converter

Exhaust manifold

Air injection system or pulse valve

e.Miscellaneous Items Used in Above Systems

Vacuum, temperature, position, time sensitive valves and switches

Connectors and assemblies

2.Length of Coverage

For a period of two years from date of original purchase, B&S warrants to the original purchaser and each subsequent purchaser that the engine is designed, built, and equipped so as to conform with all applicable regulations adopted by the Air Resources Board; that it is free from defects in material and workmanship that could cause the failure of a warranted part; and that it is identical in all material respects to the engine described in the manufacturer’s application for certification. The warranty period begins on the date the engine is originally purchased.

20

BRIGGSandSTRATTON.COM

Image 20
Contents Operator’s Manual Where to Find Us GeneratorEngine Date PurchasedTable of Contents Operator Safety Important Safety InformationSafety Symbols and Meanings Equipment DescriptionWhen Adding or Draining Fuel When Starting EquipmentWhen Operating Equipment When Transporting or Repairing EquipmentWhen Testing for Engine Spark Excessively low speeds impose a heavy loadAssembly Install Wheel KitInstall the wheel kit as follows Unpack GeneratorWhen Adding Fuel Add Engine OilAdd Fuel Fuel must meet these requirementsConnecting to a Building’s Electrical System System GroundGenerator Location Special RequirementsFeatures and Controls Items Not ShownCord Sets and Receptacles Nema L14-20120/240 Volt AC, 20 Amp, Locking Receptacle Volt AC, 20 Amp, Duplex ReceptacleOperation Starting the EngineWarm Weather Operation Connecting Electrical LoadsStopping the Engine Don’t Overload Generator Wattage Reference GuideMaintenance Maintenance ScheduleGenerator Maintenance Fuel Valve MaintenanceEngine Maintenance OilService Air Cleaner Service Spark PlugClean and inspect the spark arrester as follows Inspect Muffler and Spark ArresterStorage Troubleshooting Your Warranty Rights And Obligations Manufacturer’s Warranty CoverageOwner’s Warranty Responsibilities Briggs & Stratton Emissions Control Warranty ProvisionsExtended ModerateIntermediate Limited Warranty Reserved 800 Product SpecificationsCommon Service Parts Manual del Operario Dónde encontrarnos GeneradorMotor Fecha de compraResolución de problemas Garantías Seguridad de operarioMontaje Controles y característicasSeguridad de operario Descripción del equipoInformación importante de seguridad Símbolos sobre la seguridad y significadosCuando Anada Combustible O Vacíe EL Depósito Cuando Ponga EN Funcionamiento EL EquipoCuando Opere EL Equipo Cuando Transporte O Repare EL EquipoCuando Ajuste O Haga Reparaciones a SU Máquina Generador Cuando Pruebe LA Bujía DEL MotorMontaje Desembalaje del generadorInstale el juego de ruedas El generador se entrega conAgregar aceite al motor Agregue combustibleEl combustible debe reunir los siguientes requisitos Gran altitudTierra del sistema Conexión al sistema eléctrico de un edificioUbicación del generador Requisitos especialesControles y características No mostradoTomas eléctricas dobles de 120 V CA y 20 a Juegos de cordones y enchufes conectoresDispositivo de seguridad de 120/240 V, 20 a Operando Encienda el motorFuncionamiento en clima cálido Conexión de cargas eléctricasParada del motor No sobrecargar el generador CapacidadEjemplo Control de la energíaMantenimiento del generador MantenimientoPlan de mantenimiento Mantenimiento de la válvula de combustible Mantenimiento del motorAceite Recomendaciones sobre el aceite Comprobación del nivel de aceiteServicio del bujía Cambio de aceite del motorServicio del depurador de aire Inspeccione el silenciador y la pantalla apagachispas Limpie e inspeccione el apagachispas de la siguiente maneraSistema de refrigeración de aire Ajuste del carburadorAlmacenamiento GeneradorAlmacenamiento para periodos prolongados Cambio de aceiteResolución de problemas Problemo Causa AccionGarantías Derechos y obligaciones de la garantíaCobertura de la garantía del fabricante Responsabilidades de la garantía del propietarioBRIGGSandSTRATTON.COM Garantía Limitada Especificaciones del producto Servicio común despide