Briggs & Stratton 030242-0 manual Storage

Page 20

Storage

The generator should be started at least once every seven days and allowed to run at least 30 minutes. If this cannot be done and you must store the unit for more than 30 days, use the following guidelines to prepare it for storage.

Generator Storage

•Clean the generator as outlined in Cleaning.

•Check that cooling air slots and openings on generator are open and unobstructed.

Long Term Storage Instructions

Fuel can become stale when stored over 30 days. Stale fuel causes acid and gum deposits to form in the fuel system or on essential carburetor parts. To keep fuel fresh, use Briggs

&Stratton FRESH START™ fuel stabilizer, available as a liquid additive or a drip concentrate cartridge.

There is no need to drain gasoline from the engine if a fuel stabilizer is added according to instructions. Run the engine for 2 minutes to circulate the stabilizer throughout the fuel system. The engine and fuel can then be stored up to

24 months.

If gasoline in the engine has not been treated with a fuel stabilizer, it must be drained into an approved container. Run the engine until it stops from lack of fuel. The use of a fuel stabilizer in the storage container is recommended to maintain freshness.

WARNING

Fuel and its vapors are extremely flammable and explosive.

Fire or explosion can cause severe burns or death.

WHEN STORING FUEL OR EQUIPMENT WITH FUEL IN TANK

•Store away from furnaces, stoves, water heaters, clothes dryers or other appliances that have pilot light or other ignition source because they can ignite fuel vapors.

WHEN DRAINING FUEL

•Turn generator OFF and let it cool at least 2 minutes before removing fuel cap. Loosen cap slowly to relieve pressure in tank.

•Drain fuel tank outdoors.

•Keep fuel away from sparks, open flames, pilot lights, heat, and other ignition sources.

•DO NOT light a cigarette or smoke.

Change Engine Oil

While engine is still warm, drain oil from crankcase. Refill with recommended grade. See Changing Engine Oil.

Oil Cylinder Bore

•Remove spark plug and pour about 1/2 ounce (15 ml) of clean engine oil into the cylinder.

•Install spark plug and pull starter handle slowly to distribute oil.

WARNING

Unintentional sparking can result in fire or electric shock.

• NEVER crank engine with spark plug removed.

Other Storage Tips

1.DO NOT store fuel from one season to another unless it has been treated as described in Long Term Storage Instructions.

2.Replace fuel container if it starts to rust. Rust and/or dirt in fuel can cause problems if it’s used with this unit.

3.Cover unit with a suitable protective cover that does not retain moisture.

WARNING

Storage covers can be flammable.

•DO NOT place a storage cover over a hot generator.

•Let equipment cool for a sufficient time before placing the cover on the equipment.

4.Store generator in clean, dry area.

20

BRIGGSandSTRATTON.COM

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Operator’s Manual Where to Find Us GeneratorEngine Date PurchasedTable of Contents Operator Safety Safety RulesSafety alert symbol is used with a signal word Hazard Symbols and MeaningsEngine exhaust from this product contains Broken bones, fractures, bruises, or sprains could resultUnintentional sparking can result in fire or electric shock When Testing for Engine SparkContact with muffler area can result in serious burns Assembly Install Wheel KitInstall the wheel kit as follows Unpack GeneratorAdd Fuel Attach Negative Battery CableAdd Engine Oil Connecting to a Building’s Electrical System System GroundGenerator Location Special RequirementsFeatures and Controls Used to supply electrical power for the operationVolt AC, 20 Amp, Duplex Receptacles May be Items Not ShownCord Sets and Receptacles Nema L14-30120/240 Volt AC, 30 Amp, Locking Receptacle Volt AC, 20 Amp, Duplex ReceptaclesBattery Float Charger Operation Starting the EngineMove fuel valve to Off position Connecting Electrical LoadsStopping the Engine Don’t Overload Generator Wattage Reference GuideGenerator Maintenance MaintenanceMaintenance Schedule Oil Battery MaintenanceEngine Maintenance Service Air Cleaner Service Spark PlugInstall spark plug and tighten firmly Service Spark ArresterCheck Valve Clearance Carburetor AdjustmentAir Cooling System Storage Troubleshooting Warranties Emissions Control System WarrantyOwner’s Warranty Responsibilities Claims and Coverage Exclusions MaintenanceEmission Information Limited Warranty Page 800 Product SpecificationsCommon Service Parts Manual del Operario Dónde encontrarnos GeneradorMotor Fecha de compraResolución de problemas Garantías Seguridad de operarioMontaje Controles y característicasSeguridad de operario Descripción del equipoReglas de seguridad Símbolos de peligro y sus significadosCuando Anada Combustible O Vacíe EL Depósito Cuando Ponga EN Funcionamiento EL EquipoCuando Opere EL Equipo Cuando Transporte O Repare EL EquipoCuando Ajuste O Haga Reparaciones a SU Máquina Generador Cuando Pruebe LA Bujía DEL MotorMontaje Desembalaje del generadorInstale el juego de ruedas El generador se entrega conConecte el cable negativo de la batería Agregar aceite al motorAgregue combustible Tierra del sistema Conexión al sistema eléctrico de un edificioUbicación del generador Requisitos especialesControles y características Amperios, monofásica de 60 HzJuegos de cordones y enchufes conectores Tomas eléctricas dobles de 120 V CA y 20 aDispositivo de seguridad de 120/240 V, 30 a Amps o mayoresCargador de flotación de la batería Si el motor no arranca, repita los pasos desde 5 hasta OperandoEncienda el motor Conexión de cargas eléctricas Parada del motorEl motor podría petardear, incendiarse o dañarse Gire la válvula de combustible blanca hasta la posición OffNo sobrecargar el generador CapacidadEjemplo Control de la energíaMantenimiento del generador MantenimientoPlan de mantenimiento Mantenimiento de la batería Mantenimiento del motorAceite Recomendaciones sobre el aceite Comprobación del nivel de aceiteServicio del bujía Cambio de aceite del motorServicio del depurador de aire Limpie la Pantalla Apagachispas Limpie e inspeccione el apagachispas de la siguiente maneraSistema de refrigeración de aire Comprobación de holgura de la válvulaAlmacenamiento Resolución de problemas Problemo Causa AccionResponsabilidades de la garantía del propietario GarantíasGarantía del sistema de control de emisiones Información sobre emisiones Garantía Limitada Page Especificaciones del producto Servicio común despide
Top Page Image Contents