Briggs & Stratton 30325 manual Troubleshooting

Page 19

TROUBLESHOOTING

TROUBLESHOOTING

	Problem	Cause		Correction
		1.	One of the circuit breakers is open.	1.	Reset circuit breaker.
	Engine is running, but no	2.	Fault in generator.	2.	Contact authorized service facility.
	Engine is running, but no	3.	Poor connection or defective cord set.	3.	Check and repair.
	AC output is available.	3.	Poor connection or defective cord set.	3.	Check and repair.
	AC output is available.
		4.	Connected device is bad.	4.	Connect another device that is in
					good condition.

		1.	Short circuit in a connected load.	1.	Disconnect shorted electrical load.
	Engine runs good at no-	2.	Engine speed is too slow.	2.	Contact authorized service facility.
	load but "bogs down" when	2.	Engine speed is too slow.	2.	Contact authorized service facility.
	load but "bogs down" when	3.	Generator is overloaded.	3.	See "Don't Overload Generator".
	loads are connected.	3.	Generator is overloaded.	3.	See "Don't Overload Generator".
	loads are connected.
		4.	Shorted generator circuit.	4.	Contact authorized service facility.

		1.	Engine switch set to "Off".	1.	Set switch to "On".
		2.	Fuel Valve is in "Off" position.	2.	Turn fuel valve to "Open" position.
		3.	Dirty air cleaner.	3.	Clean or replace air cleaner.
		4.	Out of fuel.	4.	Fill fuel tank.
		5.	Stale fuel.	5.	Drain fuel tank and carburetor; fill
					with fresh fuel.
	Engine will not start; or	6.	Spark plug wire not connected to spark	6.	Connect wire to spark plug.
	Engine will not start; or		plug.
	starts and runs rough.		plug.
	starts and runs rough.	7.	Bad spark plug.	7.	Replace spark plug.
		7.	Bad spark plug.	7.	Replace spark plug.
		8.	Water in fuel.	8.	Drain fuel tank and carburetor; fill
					with fresh fuel.
		9.	Flooded.	9.	Wait 5 minutes and re-crank engine.
		10.	Excessively rich fuel mixture.	10.	Contact authorized service facility.
		11.	Intake valve stuck open or closed.	11.	Contact authorized service facility.
		12.	Engine has lost compression.	12.	Contact authorized service facility.

	Engine shuts down when	Out of fuel.		Fill fuel tank.
	running.

	Engine lacks power.	1.	Load is too high.	1.	See "Don't Overload Generator".
	Engine lacks power.	2.	Dirty air filter.	2.	Replace air filter.
		2.	Dirty air filter.	2.	Replace air filter.

	Engine "hunts" or falters.	Carburetor is running too rich or too lean.		Contact authorized service facility.

19

Image 19

Contents Operator’s Manual Manual del Operario Starting WattsCall Generator Helpline Llame Línea Directa del Generador Safety Rules Table of ContentsEquipment Description When Transporting or Repairing Equipment When Adding or Draining FuelWhen Starting Equipment When Operating EquipmentWhen Testing for Engine Spark When Adjusting or Making Repairs to Your GeneratorRecoil Starter Know Your GeneratorAlways wear eye protection when installing/removing e-rings AssemblyInstall Wheel Kit Refer to and install the wheel kit as followsType of Fuel Before Starting the EngineAdd Engine Oil Add FuelGenerator Location Using the GeneratorConnecting to a Building’s Electrical System System GroundStarting the Engine Operating GeneratorDo not Overload the GENERATOR. See Don’t Overload Generator Connecting Electrical LoadsGenerator Adapter Cord SET Stopping the Engine120/240 Volt AC, 30 Amp, Locking Receptacle ReceptaclesVolt AC, 20 Amp, Duplex Receptacles Example Power ManagementDont Overload Generator CapacityEngine Specifications Product SpecificationsPower Ratings Generator SpecificationsGenerator Cleaning Generator MaintenanceGeneral Recommendations Servicing Air Cleaner Engine MaintenanceOil Changing Engine Oil To service the air cleaner, follow these stepsServicing Spark Arrester Servicing Spark Plug Clean Cooling SystemCarburetor Adjustment Clean and inspect the spark arrester as followsGenerator StorageLong Term Storage Instructions Protect Fuel SystemTroubleshooting Owner’s Warranty Responsibilities Emissions Control System WarrantyPage Page Limited Warranty Reglas DE Seguridad Conserve Estas InstruccionesTabla DE Contenidos Descripción DEL EquipoCuando Transporte O Repare EL Equipo Cuando Añada Combustible O Vacíe EL DepósitoCuando Ponga EN Funcionamiento EL Equipo Cuando Opere EL EquipoCuando Ajuste O Haga Reparaciones a SU Generador PrecauciónCuando Pruebe LA Bujía DEL Motor Tomacorriente con Dispositivo de Seguridad de Conozca SU GeneradorTornillos Tuerca de Seguridad Asa MontajeDesembalaje del Generador Instale el Juego de RuedasCuando Añada Combustible Antes DE Darle Arranque AL MotorAgregar Aceite al Motor Agregue CombustibleConexión al Sistema Eléctrico de un Edificio USO DEL GeneradorTierra del Sistema Ubicación del GeneradorEncienda el Motor Operando EL GeneradorNo Sobrecargue EL GENERADOR.Vea No Sobrecargue Generador Juego DE Cables DEL Adaptador DEL GeneradorConexion De Cargas Electricas Parado Del MotorJuego de Cable de 4 Alambres 240V 120V Neutro Cargado Receptáculos Precaución120/240 Voltios AC, 30 Amp, Receptáculo de Seguridad Volt AC, 20 Amp, Receptáculos DoblesEjemplo No Sobrecargue GeneradorCapacidad Control de la EnergíaEspecificaciones del Generador Información Técnica Sobre EL MotorEspecificaciones DEL Producto Potencia NominalMantenimiento DEL Generador Recomendaciones GeneralesLimpieza del Generador Aceite Mantenimiento DEL Motor AdvertenciaServicio del Depurador de Aire Tapa Cambio de Aceite del MotorLimpie la Pantalla Apagachispas CartuchoAjuste del Carburador Limpie/Reemplace la BujíaSistema de Refrigeración de Aire Compruebe la Holgura de la VálvulaGenerador AlmacenamientoAlmacenamiento Para Periodos Prolongados Proteja el Sistema de CombustibleDiagnositicos DE Averías Problemo Causa AccionGarantía DEL Sistema DE Control DE Emisiones = 250 horas, B = 500 horas y a = 1000 horas Uso comercial Uso del consumidor