Briggs & Stratton 30325 manual When Adjusting or Making Repairs to Your Generator

Page 4

SAFETY RULES

WARNING

Rapid retraction of starter cord (kickback) will pull hand and arm toward engine faster than you can let go.

Broken bones, fractures, bruises or sprains could result.

•When starting engine, pull cord slowly until resistance is felt and then pull rapidly to avoid kickback.

•NEVER start or stop engine with electrical devices plugged in and turned on.

WARNING

Unintentional sparking can result in fire or electric shock.

WHEN ADJUSTING OR MAKING REPAIRS TO YOUR GENERATOR

•Disconnect the spark plug wire from the spark plug and place the wire where it cannot contact spark plug.

WHEN TESTING FOR ENGINE SPARK

•Use approved spark plug tester.

•DO NOT check for spark with spark plug removed.

WARNING

Running engines produce heat.Temperature of muffler and nearby areas can reach or exceed 150°F (65°C).

Severe burns can occur on contact.

Exhaust heat/gases can ignite combustibles, structures or damage fuel tank causing a fire.

•DO NOT touch hot surfaces and avoid hot exhaust gases.

•Allow equipment to cool before touching.

•Keep at least 5 ft. (152 cm) clearance on all sides of generator including overhead.

•Code of Federal Regulation (CFR) Title 36 Parks, Forests, and Public Property require equipment powered by an internal combustion engine to have a spark arrester, maintained in effective working order, complying to USDA Forest service standard 5100-1C or later revision. In the State of California a spark arrester is required under section 4442 of the California Public resources code. Other states may have similar laws.

CAUTION

Excessively high operating speeds increase risk of injury and damage to generator.

Excessively low speeds impose a heavy load.

•DO NOT tamper with governed speed. Generator supplies correct rated frequency and voltage when running at governed speed.

•DO NOT modify generator in any way.

CAUTION

Exceeding generators wattage/amperage capacity can damage generator and/or electrical devices connected to it.

•See “Don’t Overload Generator”.

•Start generator and let engine stabilize before connecting electrical loads.

•Connect electrical loads in OFF position, then turn ON for operation.

•Turn electrical loads OFF and disconnect from generator before stopping generator.

CAUTION

Improper treatment of generator can damage it and shorten its life.

•Use generator only for intended uses.

•If you have questions about intended use, ask dealer or call 1-800-743-4115.

•Operate generator only on level surfaces.

•DO NOT expose generator to excessive moisture, dust, dirt, or corrosive vapors.

•DO NOT insert any objects through cooling slots.

•If connected devices overheat, turn them off and disconnect them from generator.

•Shut off generator if:

-electrical output is lost;

-equipment sparks, smokes, or emits flames; -unit vibrates excessively.

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Operator’s Manual Manual del Operario Starting WattsCall Generator Helpline Llame Línea Directa del Generador Safety Rules Table of ContentsEquipment Description When Adding or Draining Fuel When Starting EquipmentWhen Operating Equipment When Transporting or Repairing EquipmentWhen Adjusting or Making Repairs to Your Generator When Testing for Engine SparkKnow Your Generator Recoil StarterAssembly Install Wheel KitRefer to and install the wheel kit as follows Always wear eye protection when installing/removing e-ringsBefore Starting the Engine Add Engine OilAdd Fuel Type of FuelUsing the Generator Connecting to a Building’s Electrical SystemSystem Ground Generator LocationOperating Generator Starting the EngineConnecting Electrical Loads Generator Adapter Cord SETStopping the Engine Do not Overload the GENERATOR. See Don’t Overload Generator120/240 Volt AC, 30 Amp, Locking Receptacle ReceptaclesVolt AC, 20 Amp, Duplex Receptacles Power Management Dont Overload GeneratorCapacity ExampleProduct Specifications Power RatingsGenerator Specifications Engine SpecificationsGenerator Cleaning Generator MaintenanceGeneral Recommendations Servicing Air Cleaner Engine MaintenanceOil Changing Engine Oil To service the air cleaner, follow these stepsServicing Spark Arrester Clean Cooling System Carburetor AdjustmentClean and inspect the spark arrester as follows Servicing Spark PlugStorage Long Term Storage InstructionsProtect Fuel System GeneratorTroubleshooting Emissions Control System Warranty Owner’s Warranty ResponsibilitiesPage Page Limited Warranty Conserve Estas Instrucciones Tabla DE ContenidosDescripción DEL Equipo Reglas DE SeguridadCuando Añada Combustible O Vacíe EL Depósito Cuando Ponga EN Funcionamiento EL EquipoCuando Opere EL Equipo Cuando Transporte O Repare EL EquipoCuando Ajuste O Haga Reparaciones a SU Generador PrecauciónCuando Pruebe LA Bujía DEL Motor Conozca SU Generador Tomacorriente con Dispositivo de Seguridad deMontaje Desembalaje del GeneradorInstale el Juego de Ruedas Tornillos Tuerca de Seguridad AsaAntes DE Darle Arranque AL Motor Agregar Aceite al MotorAgregue Combustible Cuando Añada CombustibleUSO DEL Generador Tierra del SistemaUbicación del Generador Conexión al Sistema Eléctrico de un EdificioOperando EL Generador Encienda el MotorJuego DE Cables DEL Adaptador DEL Generador Conexion De Cargas ElectricasParado Del Motor No Sobrecargue EL GENERADOR.Vea No Sobrecargue GeneradorReceptáculos Precaución 120/240 Voltios AC, 30 Amp, Receptáculo de SeguridadVolt AC, 20 Amp, Receptáculos Dobles Juego de Cable de 4 Alambres 240V 120V Neutro CargadoNo Sobrecargue Generador CapacidadControl de la Energía EjemploInformación Técnica Sobre EL Motor Especificaciones DEL ProductoPotencia Nominal Especificaciones del GeneradorMantenimiento DEL Generador Recomendaciones GeneralesLimpieza del Generador Aceite Mantenimiento DEL Motor AdvertenciaServicio del Depurador de Aire Cambio de Aceite del Motor Limpie la Pantalla ApagachispasCartucho TapaLimpie/Reemplace la Bujía Sistema de Refrigeración de AireCompruebe la Holgura de la Válvula Ajuste del CarburadorAlmacenamiento Almacenamiento Para Periodos ProlongadosProteja el Sistema de Combustible GeneradorProblemo Causa Accion Diagnositicos DE AveríasGarantía DEL Sistema DE Control DE Emisiones = 250 horas, B = 500 horas y a = 1000 horas Uso del consumidor Uso comercial
Top Page Image Contents