Baldor ISO9001 manual Operation Starting

Page 34

OPERATION - PRE-START PROCEDURE

1. Fill system fuel tank with clean, fresh diesel fuel.

Wipe up any and all fuel spillage

2.Fill Engine crankcase to full mark with clean, fresh lubricating oil per attached engine operating guide.

3.Radiator Coolant should be checked at the beginning of each day and filled in compliance with the engine manufacturer's guidelines.

4.Secure the generator for operation.

Skid mounted - the power generating system should be mounted to a smooth, hard surface suitable for supporting the system under all stress conditions.

Adequate clearance must be provided for access doors to fully open.

OPERATION - STARTING

1.Conduct ‘Pre-start Procedures.

2.Switch the generator set to the applicable voltage setting.

3.Connect the load(s) to the circuit breaker.

WARNING: High voltage is present when the generator set is running.

4. Move the ‘Master Control Switch” to the appropriate position.

5. Adjust the voltage if necessary by turning the voltage adjustment knob located on the control panel.

Image 34

Contents Standby Permanent Mount Series Generator Forward Page Page Ż ż for Gasoline or Diesel Powered Generator Sets ż ż ż ż Ż ż for Gasoline or Diesel Powered Generator Sets ż ż ż ż Standby PERMANENT- Mount Series Generator Baldor Generator Features Options BaldorFarm Duty 1-Phase Model DLC25 Engine SpecificationsModel D50 Farm Duty 1-Phase Model DLC50 PowerPACModel D60 Farm Duty 1-Phase Model DLC60 Engine SpecificationsModel D75 Farm Duty 1-Phase Model DLC75 Engine DataModel D100 Farm Duty 1-Phase Model DLC100Model D130 Farm Duty 1-Phase Model DLC130 Hard Wire Load Terminal Block Electrical Connection InformationConnection Information Engine Cooling Requirements Generator Mounting RequirementsStandby Permanent Mount Series Generator Engine Cooling AIR HOT Exhaust Gases Backpressure must not exceed 20 of water columnPage Building Ventilation Generator END Cooling AIRBuilding Ventilation Exhaust Requirements Exhaust PipingExhaust Piping Thru Walls and Roofs Exhaust Thimble Minimum O.DDouble Thimble Roof Outlet Details Control Panel Operation Function Page Page Operation Starting Operation Cranking Control No Voltage LOW VoltageHigh Voltage Fluctuating VoltageOverheating Generator Frame Produces Shock When Touched Mechanical NoiseTroubleshooting Engine Limited Warranty Warranty Period Limitations KVA Distributor Information END User / Owner InformationRPM CurrentPre Start-Up Check List Start-Up Procedure Oregon Street Oshkosh WI Phone 920-239-4200 Fax California Proposition 65 Warning Oregon Street Oshkosh WI Phone 920 236-4200 Fax 920