Baldor ISO9001 manual Pre Start-Up Check List Start-Up Procedure

	Pre Start-Up Check List	Start-Up Procedure
	No Freight Damage (Components Tight, Straight,	Check That All Applicable Warning Decals Are In
	Etc.).	Their Proper Place And Are Legible.
	Proper Belt Alignment And Tensions.	The ATS Engine Start Wires and other DC Wires,
		if Any, Must be Properly Connected.
	Flex Fuel Lines Installed Between Engine And	All Wiring Connections are Tight.
	Tank.
	Fluid Levels (Oil, Antifreeze, Battery, Governor,	The Equipment Room is Clean & All Unrelated
	Etc.) Check For Leaks, Tighten As Necessary.	Materials Removed.
	Correct Fuel And Exhaust Plumbing.	The Equipment is Protected from Possible Fire
		Damage by Fire Extinguisher System.
	Adequate Air Flow.	Earthquake Protection (when Applicable) is
		Adequate for the Equipment.
	Correct AC Wire Sizes And Connections.	Open Generator Mainline Breaker or Remove
		Fuses.
	Correct DC Wire Sizes And Connections (Route	Turn Down Speed Potentiometer (Electronic
		Governor) or Speed Screw (Mechanical
	Separate From AC).
		Governor).
	Block Heater Is Operational.	Move Switch to "Manual". let the Engine Start &
		Run.
	Bleed And Prime The Fuel System; Check For	After a Few Minutes, Check Oil Pressure & Check
	Leaks. Correct As Necessary.	for Leaks.
	On Natural Gas Fueled Sets, Gas Pressure Of 4-6	Adjust the Speed to 60/50hz if Equipped with
	Oz. Of Pressure With Adequate Volume Is	Electronic Governor or 63/53 Hz with Mechanical
	Available.	Governor.
	Gas Solenoid Valve Is Properly Functioning.	If Speed is Unstable, Adjust Per Engine or
		Governor Manual.
	Exhaust Line and Flexible Connections are	Adjust the AC Voltage to Match the Normal
	Properly Installed Without Excessive Bends and
		Source.
	Restrictions.
	Exhaust System Termination Properly Located to	Let the Unit Run Until Engine Reaches Proper
	Prevent Entry of Exhaust Gas Into Building.	Water Temp.
	Batteries Properly Filled with Electrolyte &	Close Generator Mainline Breaker or Replace
	Properly Connected to the Engine.	Fuses..
	Battery Charger Must Be Properly Installed &	Manually Over-Speed the Unit Until Engine
	Connected to the Battery. Battery Must Be Fully	Shutdown (68-70 Hz or 60 Hz Generators ; 58-60
	Charged Prior to Start-up.	Hz on 50 Hz Generator Sets.
	Generator Load Connectors of Proper Ampacity	Test Automatic Shut-Downs (Low Oil Pressure,
	are Connected to Either the Circuit Breaker or the	Low Coolant Level, High Coolant Temperature,
	Emergency Side of the Transfer Switch.	Overspeed set to ______Hz Other______)
	The Nameplate Voltage & Frequency of the	**INSTRUCT END USER ON FUNCTIONS OF
		UNIT***. Set Times to Customer's Request and
	Genset Matches that of ATS & Normal Source.
		Run a Simulated Power Outage.
		Instruct the Customer in Proper Operation &
		Maintenance of the System and Make Sure They
		Have Correct Manuals.
Comments:

RETURN THIS COMPLETED FORM TO:

Baldor Generators ƒ 3815 Oregon Street ƒ Oshkosh WI 54902