User’s Manual
Uncompressed Initialization Codes — The following runtime checkpoint hex codes are listed in order of execution. These codes are uncompressed in F0000h shadow RAM.
|
|
|
|
| Code | Description |
|
|
|
|
|
| 03 | The NMI is disabled. Next, checking for a soft reset or a power on |
|
|
| condition. |
|
| 05 | The BIOS stack has been built. Next, disabling cache memory. |
|
| 06 | Uncompressing the POST code next. |
|
| 07 | Next, initializing the CPU and the CPU data area. |
|
| 08 | The CMOS checksum calculation is done next. |
|
| 0B | Next, performing any required initialization before the keyboard BAT |
|
|
| command is issued. |
|
| 0C | The keyboard controller input buffer is free. Next, issuing the BAT |
|
|
| command to the keyboard controller. |
|
| 0E | The keyboard controller BAT command result has been verified. Next, |
|
|
| performing any necessary INIT after the K/B controller BAT command |
|
|
| test. |
|
| 0F | The keyboard command byte is written next. |
|
| 10 | Next, issuing the pin 23 and 24 blocking and unblocking commands. |
|
| 11 | Next, checking if the <End> or <Ins> keys were pressed during power |
|
|
| on. |
|
| 12 | To initialize CMOS if the initialize CMOS RAM in every boot is set or |
|
|
| the <End> key is pressed. Going to disable DMA and Interrupt |
|
|
| controllers. |
|
| 13 | The video display has been disabled. Port B has been initialized. Next, |
|
|
| initialising the chipset. |
|
| 14 | The 8254 timer test will begin next. |
|
| 19 | The 8254 timer test is over. Starting the memory refresh test next. |
|
| 1A | The memory refresh line is toggling. Checking the 15us on/off time |
|
|
| next. |
|
| 23 | Reading the 8042 input port and disabling the MEGAKEY Green PC |
|
|
| feature next. Making the BIOS code segment writable and performing |
|
|
| any necessary configuration before initializing the interrupt vectors. |
|
| 24 | The configuration or setup required before interrupt vector initialization |
|
|
| has completed. Interrupt vector init. is about to begin |
|
| 25 | Interrupt vector initialization is done. Clearing the password if the |
|
|
| POST DIAG switch is on. |
|
| 27 | Any initialization before setting video mode to be done. |
|
| 28 | Going for monochrome mode and color mode setting. |
|
|
|
|
|
98