Intel ECB-865 user manual Systems’ DiskOnChip Flash Disk, Installing DOC

ECB-865

3.5M-Systems’ DiskOnChip Flash Disk

ECB-865 reserves a 32-pin DIP socket to support M-Systems’ DiskOnChip flash disk up to 288 MB. The DiskOnChip is based on pure ISA bus and without PnP (Plug and Play) function. Before the installation, make sure that the DiskOnChip I/O address jumper is set properly to prevent the I/O resource conflict.

3.5.1Installing DOC

Align the DOC with the pinholes on the socket. Make sure that the notched corner or dot mark (pin 1) of DOC corresponds to notched corner of the socket. Then press the DOC gently until it fits into place. If installation procedure is correct, the flash disk can be viewed as a normal hard disk to access read/write data now.

Note:

Please make sure that your DOC is properly inserted. Place the DOC in wrong direction will damage the flash device.

If you system would like to boot from the flash disk, it is recommended to refer to the application note provided by M-Systems first. You can easily obtain the application note from M-Systems’ DiskOnChip user’s manual or from their web site as below.

http://www.m-sys.com

3.6Expansion Interface

The ECB-865 reserves an 80-pin proprietary PCI interface, J22, for PCI device such as LAN, Audio, SCSI, Video Capture expansion in the future. This installation of expansion module is very simple and easy. Without any special tool, all you need to do is just make the board-to-board connection and lock up the screw. For more information about the expansion module, please refer to the instruction manual attached with each module.

3.7Installing the Single Board Computer

To install your ECB-865 into chassis or proprietary environment, the following steps have to be followed.

Make sure all jumpers are properly set.

Install and configure CPU and memory module correctly.

Place the ECB-865 into the dedicated position in your system.

Attach cables to peripherals.

Note:

Please ensure that your SBC is properly installed and fixed by mechanism. Otherwise, the system might be unstable or do not work due to bad contact of golden finger and slot.

ECB-865 User’s Manual 13