Intel SE7500WV2 manual Processor, Memory, PCI Riser Slots, Video

Page 10

Processor

The SE7500WV2 accommodates one or two Intel Xeon processors with 512k cache in the INT3/FCPGA Socket 604 package. This processor uses the .13 micron technology. Check the Intel Customer Support website for the latest list of supported processors see:

http://support.intel.com/

Memory

The system board has six 168-pin DIMM slots each supporting 72-bit ECC registered DDR DIMMs (DDR-200 or DDR-266 compatible). Memory is partitioned in three banks. You may install a minimum of 256 MB (128MB x 2) and as much as 12 GB. Memory must be installed in pairs, starting with bank 1 (slots 1B and 1A).

The controller automatically detects, sizes, and initializes the memory array, depending on the type, size, and speed of the installed DIMMs, and reports memory size and allocation to the server via configuration registers.

✏NOTE

Use DIMMs that have been tested for compatibility with the server board. Contact your sales representative or dealer for a current list of approved memory modules. Check the Intel Customer Support website for the latest tested memory list.

http://support.intel.com/

PCI Riser Slots

The server board has two PCI riser slots. Riser slot B provides the following features:

•184 pin, 5 volt keyed, 64-bit expansion slot connector

•Support for either a 1-slot or a 3-slot PCI riser card

•Support for both full length and low profile PCI cards

Riser C provides the following features:

•184 pin, 5 volt keyed, 64-bit expansion slot connector

•Support for either a 1-slot or a 3-slot PCI riser card

•Support for only low profile PCI cards

Video

The SE7500WV2 uses an ATI RAGE XL PCI graphics accelerator with 8 MB of video SDRAM. The embedded SVGA video subsystem supports:

•Resolutions up to 1600 x 1200 under 2D and 1024 x 768 under 3D

•CRT and LCD monitors up to 100 Hz vertical refresh rate

The server board supports disabling of the onboard video through the BIOS setup menu or when a plug in video card is installed in any of the PCI slots.

10	Intel Server Board SE7500WV2 Product Guide

Image 10

Contents Intel Server Board SE7500WV2 Product Guide Page Contents Configuration Software and Utilities UpgradingTechnical Reference Solving ProblemsEquipment Log and Power Consumption Worksheets Regulatory and Integration InformationFigures TablesDescription Server Board FeaturesServer Board Features Server Board VersionsServer Board Connector and Component Locations Server Board Connector and Component LocationsBack Panel Connectors Back Panel ConnectorsPCI Riser Slots ProcessorMemory VideoScsi Controller ATA-100 ControllerKeyboard and Mouse NIC Connector and Status LEDsNetwork Controller RJ-45 Serial PortRear Serial 2 Port Adapter Pin-out RJ-45 SignalAbbreviation System Management Baseboard Management ControllerSystem Event Log Field Replaceable Units and Sensor Data RecordsPlatform Event Management Intel Server Management Emergency Management PortEMP and Serial Over LAN Security Intrusion Switch MonitoringUsing Passwords Software LocksSecure Mode Summary of Software Security Features Software Security FeaturesBoot without keyboard Installation Procedures Rearrange the StandoffsInstall the Server Board Installing the Server BoardInstall the Processor Retention Brackets Installing ProcessorsLower the locking bar completely Installing the Heat Sink Installing the Heat Sink Clip Installing Memory Connecting Cables Connect CablesInstalling a Service Partition on the Server Optional Installing Intel Server Management Installing your Operating SystemInstalling Intel SMaRT Tool Upgrading Tools and Supplies NeededInstalling DIMMs Processors Adding or Replacing a ProcessorLower the locking bar completely Installing the Heat Sink Replacing the Back up Battery Removing a ProcessorReplacing the Back up Battery Intel Server Board SE7500WV2 Product Guide Configuration Utilities Configuration Software and UtilitiesService Partition Optional System Software Update SequenceHot Keys Power-On Self-Test PostHot Keys To Do ThisIf Bios Setup Is Inaccessible Bios SetupTemporarily Changing the Boot Device Priority Running the Adaptec SCSISelect Utility When to Run the Adaptec SCSISelect UtilityConfiguring the Adaptec AIC-7899 Scsi Adapter Running the SCSISelect UtilityDirect Platform Control DPC Console When to Run the Promise FastBuild UtilityRunning the Promise FastBuild Utility Running the Promise FastBuild UtilityDPC Console Modes of Operation Running the DPC Console Using the System Setup UtilityCreating SSU Diskettes Working with the SSU Interface Running the SSUCustomizing the SSU Interface Setting the Administrator Password Setting Boot Device PrioritySetting Passwords and Security Options Exiting the SSUSetting Security Options Setting the User PasswordViewing the System Event Log Viewing FRU Information Viewing Sensor Data RecordsUpdating the Firmware Updating System Firmware and BiosUpdating the Bios Verifying the FirmwareRestoring a Configuration Saving and Restoring the System ConfigurationSaving a Configuration Setting Up Paging AlertsIntel Server Board SE7500WV2 Product Guide Setting Up LAN Alerts Setting Up Remote Modem or Serial Access Setting Up Remote LAN AccessManaging the Server Remotely Software Updates Creating a Bootable DisketteRecovering the Bios Software Update PackageRunning the Firmware Update Utility Firmware Update Utility DescriptionFRU/SDR Load Utility Description What You Need to Do Command Line FormatCommand How You Use the FRU/SDR Load UtilityPrompting for Product Level FRU Information Intel Server Board SE7500WV2 Product Guide Checklist Solving ProblemsResetting the System Initial System StartupRunning New Application Software After the System Has Been Running CorrectlyVerifying Proper Operation of Key System Lights More Problem Solving ProceduresMonitoring Post Confirming Loading of the Operating SystemPower Light Does Not Light Specific Problems and Corrective ActionsNo Characters Appear on Screen System Cooling Fans Do Not Rotate Properly Characters Are Distorted or IncorrectDiskette Drive Activity Light Does Not Light Bootable CD-ROM Is Not Detected Problems with NetworkProblems with Application Software CD-ROM Drive Activity Light Does Not LightAdd-in adapter stopped working without apparent cause Cannot Connect to a ServerIntel Server Board SE7500WV2 Product Guide Server Board Jumpers What it does at system resetTechnical Reference Jumper NamePost Codes Diagnostic LEDsDiagnostic LED Decoder Post Code0Fh 2Bh Off 2Dh 82h Off Error Code Post Error Codes and MessagesStandard Post Error Messages and Codes Error Message119 11A 11B 11E 120 121 140 141 142 143 144 145 146 Extended Post Error Messages and Codes Bios Recovery Beep Codes Bios Recovery Beep CodesBootblock Error Beep Codes Bootblock Error Beep CodesIntel Server Board SE7500WV2 Product Guide Product Regulatory Compliance Product Safety ComplianceRegulatory and Integration Information Product EMC ComplianceProduct Regulatory Compliance Markings Electromagnetic Compatibility Notices FCC USAEurope CE Declaration of Conformity Bsmi TaiwanEquipment Log and Power Consumption Worksheets Equipment LogManufacturer Name Serial Number Date InstalledModel Number Power Usage Worksheet Calculating Power ConsumptionWorksheet, Calculating DC Power Usage Current UsageVoltage level and total current V X a = W Worksheet, Total Combined Power Used by the SystemTotal Watts For each voltage level Index Intel Server Board SE7500WV2 Product Guide