Sanyo PLC-XL45 owner manual Installation, Positioning the Projector, Adjustable Feet

Installation

Positioning the Projector

For the projector positioning, see the figures below.

The projector should be set perpendicularly to the plane of the screen.

✔Note:

•This projector is not equipped with an optical zoom. To adjust the screen size, change the throw distance. •The brightness in the room has a great influence on picture quality. It is recommended to limit the ambient lighting in order to get the best image.

•All measurements are approximate and may vary from the actual sizes.

3.215’ (0.98 m)

(Inch Diagonal)

3.018’ (0.92 m)

80”

2.789’ (0.85 m)

75”

2.592’ (0.79 m)

70”

2.395’ (0.73 m)

65”

60”

A

Screen Size

60”

65”

70”

75”

80”

(W x H) mm

1219 x 914

1321 x 991

1422 x 1067

1524 x 1143

1626 x 1219

4:3 aspect ratio

Throw distance

2.395’ (0.73 m)

2.592’ (0.79 m)

2.789’ (0.85 m)

3.018’ (0.92 m)

3.215’ (0.98 m)

A

0.417’ (12.7 cm)

0.433’ (13.2 cm)

0.446’ (13.6 cm)

0.459’ (14.0 cm)

0.476’ (14.5 cm)

Adjustable Feet

Projection angle can be adjusted up to 10.0 degrees with the adjustable feet.

1	Lift the front of the projector and pull the feet lock
	latches on both sides of the projector upward.
2	Release the feet lock latches to lock the adjustable feet
	and rotate the adjustable feet to adjust the position
	and tilt.
3	To retract the adjustable feet, lift the front of the
	projector and pull and undo the feet lock latches.

Keystone distortion of the projected image can be corrected by menu operation (pp.22, 41).

Feet Lock Latches

Adjustable Feet

http://www.pureglare.com.au 13