Setting
On start
When this function is set to “On,” the projector is automatically turned on just by connecting the AC power cord to an outlet.
✔Note:
•Be sure to turn the projector off properly (see “Turning Off the Projector” on page 19). If the projector is turned off in the incorrect sequence, the On start function does not operate properly.
Lamp control
You can change the brightness of the screen.
Normal … Normal brightness
Auto …… Brightness according with the input signal
Eco …… Lower brightness reduces the lamp power
consumption and extends the lamp life.
Remote control
This projector provides two different remote control codes; the
When the projector is operated in “Code 2,” both the projector and the remote control must be switched to “Code 2.”
To change the code for the projector:
Select either “Code 1” or “Code 2” in this Setting Menu.
To change the code for the remote control: Press and hold both the MENU and IMAGE buttons together for more than 5 seconds. After changing the code, make sure the remote control operates properly.
✔Note:
•When different codes are set on the projector and on the remote control, any operation cannot be made. In that case, switch the code on the remote control to fit the code on the projector.
•if the batteries are removed from the remote control for a long period of time, the remote control code will be reset.
On start
Remote control
Press and hold MENU and IMAGE buttons for more than 10 seconds.
46 | http://www.pureglare.com.au |