Sanyo PLC-XL45 owner manual Appendix Indicators and Projector Condition

Appendix

Indicators and Projector Condition

Check the indicators for projector condition.

Indicators

POWER	WARNING	LAMP	Projector Condition
red/green	red	REPLACE
		yellow
			The projector is off. (The AC power cord is unplugged.)
			The projector is preparing for stand-by or the projection lamp is
		✽	being cooled down. The projector cannot be turned on until cooling is
			completed.
		✽	The projector is ready to be turned on with the POWER ON-OFF
			button.
		✽	The projector is operating normally.
		✽	The projector is in the Power management mode.
			The temperature inside the projector is abnormally high. The projector
			cannot be turned on. When the projector is cooled down enough and
		✽	the temperature returns to normal, the POWER indicator lights red
			and the projector can be turned on. (The WARNING indicator keeps
			blinking.) Check and clean the air filters.
			The projector has been cooled down enough and the temperature
		✽	returns to normal. When turning on the projector, the WARNING
			indicator stops blinking. Check and clean the air filters.

The projector detects an abnormal condition and cannot be turned on.

Unplug the AC power cord and plug it again to turn on the projector. If

✽the projector is turned off again, unplug the AC power cord and contact the dealer or the service center for service and checkup. Do not leave the projector on. It may cause an electric shock or a fire hazard.

• • • green.	• • • red	• • • off
• • • blinks green.	• • • blinks red.

✽When the projection lamp reaches the end of its life, the LAMP REPLACE indicator lights yellow. When this indicator lights yellow, replace the projection lamp with a new one promptly. Reset the lamp replacement counter after replacing the lamp. See pages 53–54.

http://www.pureglare.com.au 59