Setting
Input search
This function detects the input signal automatically. When finding a signal, the search will stop. Use the Point 7 8 buttons to select one of the following.
Off …… Input search does not work.
On1 …… Input search works under the situation below.
•When the INPUT button on the top control is pressed.
•When the COMPUTER button or VIDEO button on the remote control is pressed.
On2 …… Input search works under the situation below.
•When the projector is turned on with pressing the POWER
•When the current input signal is missed. ✳ •When the INPUT button on the top control is pressed.
✳If the No show or Freeze function is active, cancel it to activate the Input search. It is not available when On‑Screen menu is displayed.
Power management
For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the input signal is interrupted and no button is pressed for a certain period.
When the input signal is interrupted and no button is pressed for more than 30 seconds, the timer display with “No signal” appears. The countdown starts to turn off the lamp.
Select one of the operations.
Ready………When the lamp has been fully cooled
down, the POWER indicator changes to green blinking. In this condition, the projection lamp is turned on if the input signal is reconnected or any button on the top control or on the remote control is pressed.
Shut down…When the lamp has been fully cooled down, the power is turned off.
Off………… Power management function is off.
Then set the countdown timer with the Point 7 8 buttons.
✔Note:
• Factory default is “Ready: 5 min.”
✔Note:
•While Input search is set On1 or On2, the status of Input and Lamp are displayed every time the signal is switched.
•Only the input source selected at the last time can be detected.
•If any of the INPUT button on the top control or COMPUTER/VIDEO button on the remote control is pressed while Input search is on, Input search will stop and go back to the previous input sign.
Power management
Time left before Lamp is off.
Press the SELECT button at Power management and this box appears. Select one of three settings with the Point 7 8 buttons, and go to the timer with the Point ed buttons and set time with the Point 7 8 buttons.
http://www.pureglare.com.au | 45 |