Computer Input
Input Source Selection
Direct Operation
Press the INPUT button on the top control or the COMPUTER button on the remote control to select either Computer 1 or Computer 2.
Before using the INPUT or COMPUTER buttons, select the correct input source through Menu operation as described below.
Top Control |
|
| |
| POWER | WARNING LA | |
ON | MENU | INPUT | KE |
- |
|
|
|
OFF |
|
|
|
| SELECT |
|
|
Remote Control
INPUT button
INPUT button
Computer 1
Computer 2*
Video
COMPUTER button
COMPUTER button
Computer 1
Computer 2*
Menu Operation
1 | Press the MENU button to display the |
| Menu. Use the Point 7 8 buttons to move the red |
| frame pointer to the Input Menu icon. |
2 | Use the Point ed buttons to move the red arrow |
| pointer to either Computer 1 or Computer 2, and then |
| press the SELECT button. |
3 | After the Source Select Menu appeared for Computer |
| 1, move the pointer to RGB and then press the |
SELECT button.
✔Note:
•Computer 2 is not displayed when the COMPUTER IN 2/ MONITOR OUT terminal is set as Monitor out (p.44). •Computer 2 (COMPUTER IN 2/MONITOR OUT) can accept only the RGB signal.
•When the Input Search function is set On1 or On2, the input signal will be searched automatically (p.45)
*See Notes at the bottom of this page. Input Menu icon
Input Menu
Move the pointer (red arrow) to Computer 1 and press the SELECT button.
Computer
1
Source Select Menu
Move the pointer to RGB and press the SELECT button.
Input Menu
Move the pointer (red arrow) to Computer 2 and press the SELECT button.
http://www.pureglare.com.au | 25 |