Video Input
Input Source Selection (Video, S-Video)
Direct Operation
Press the INPUT button on the top control or VIDEO button on the remote control to select “Video.”
Before using INPUT or VIDEO buttons, select the correct input source through menu operation as described below.
Top Control
| POWER | WARNING LAMP RE | |
ON | MENU | INPUT | KEYSTON |
- |
|
| |
OFF |
|
|
|
| SELECT |
|
|
|
|
| + |
-VO
VO 
INPUT button
INPUT button
Video
Computer 1
Computer 2*
*See Note at the bottom of this page.
Remote Control
Menu Operation
1 | Use the MENU button to display the |
| Press the Point 7 8 buttons to move the red frame |
| pointer to the Input Menu icon. |
2 | Use the Point ed buttons to move the red arrow |
| pointer to Video and then press the SELECT button to |
| display the Source Select Menu . |
3 | Move the pointer to the desired source and then press |
| the SELECT button. |
Auto When selecting “Auto,” the projector automatically detects the incoming video signal, and adjusts itself to optimize its performance. The projector selects connection in the following order:
1.
2.Video
Video When the video input signal is connected to the VIDEO jack, select Video.
✔Note:
•Computer 2 is not displayed when the COMPUTER IN 2/ MONITOR OUT terminal is set as Monitor out (p.44).
•When the Input Search function is set On1 or On2, the input signal will be searched automatically (p.45)
Input Menu
VIDEO
VIDEO button
Input Menu icon
Move the pointer to Video and press the SELECT button.
Source Select Menu (VIDEO)
Move the pointer to the desired source and press the SELECT button.
34 | http://www.pureglare.com.au |