Sanyo PLC-XL45 owner manual Appendix, Computer 2 cannot be selected

Appendix

Some displays are not seen during	–  Check the Display function (see page 41).
the operation.

PIN code dialog box appears at start-up.

–  PIN code lock is being set. Enter a PIN code; the “1234” or numbers you have set (see pages 18, 47–48).

Computer 2 cannot be selected.	–  Select Computer 2 in the Terminal function (see page 44).
	– The Terminal function cannot be selected after Computer 2 is
The Terminal function cannot be	selected. Select other input source such as Computer 1 or Video
selected.	with the COMPUTER button or the VIDEO button on the remote
	control so that the Terminal function can be selected.
	–  Check the batteries.
	–  Make sure no obstruction is between the projector and the remote
	control.
The Remote Control does not work.	–  Make sure you are not too far from the projector when using the
	remote control. Maximum operating range is 16.4’ (5 m).
	–  Make sure the code of the remote control is conformed to that of
	the projector (see page 46).
	–  Unlock the Key lock function for the remote control (see page 47).

Top Control does not work.

–  Unlock Key lock for the projector in the Key lock function. (See page 47.)

WARNING :

High voltages are used to operate this projector. Do not attempt to open the cabinet.

If problems still persist after following all operating instructions, contact the dealer where you purchased the projector or the service center. Specify the model number and explain about the problem. We will advise you how to obtain service.

The CE Mark is a Directive conformity mark of the European Community (EC).

This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty and electrical hazards.

	Pixelworks ICs used.
56	http://www.pureglare.com.au