Sanyo PLC-XL45 owner manual Source Select Menu, RGB Scart

Video Input

Input Source Selection (Component, RGB Scart 21-pin)

Direct Operation

Press the INPUT button on the top control or COMPUTER button on the remote control to select Computer 1. Before using INPUT or COMPUTER buttons, select the correct input source through Menu operation as described below.

Menu Operation

1	Use the MENU button to display the On-Screen Menu.
	Press the Point 7 8 buttons to move the red frame

Top Control

	POWER	WARNING LAMP R
ON	MENU	INPUT	KEYSTO
-
OFF
	SELECT
			+
	-		V
	VO

Remote Control

INPUT button

INPUT button

Computer 1

Computer 2*

Video

COMPUTER button

COMPUTER button

Computer 1

Computer 2*

	pointer to the Input Menu icon.
2	Use the Point ed buttons to move the red arrow
	pointer to Computer 1 and then press the SELECT
	button.
3	After the Source Select Menu appeared for Computer
	1, move the pointer to Component or RGB (Scart) and

then press the SELECT button.

Component When the input source is coming from video equipment connected to the

COMPUTER IN 1/COMPONENT IN terminal with a Component-VGA Cable (not supplied), select Component.

*See Note at the bottom of this page.

Input Menu		Input Menu icon
		Move the pointer (red arrow)
		to Computer 1 and press the
		SELECT button.
	Computer
1
		Source Select Menu
		Move the pointer to Component

RGB (Scart)

✔Note:

When the input source is coming from video equipment connected to the

COMPUTER IN 1/COMPONENT IN terminal with a Scart-VGA Cable (not supplied), select RGB (Scart).

or RGB (Scart) and press the

SELECT button.

•Computer 2 is not displayed when the COMPUTER IN 2/ MONITOR OUT terminal is set as Monitor out (p.44). •Computer 2 (COMPUTER IN 2/MONITOR OUT) can accept only RGB signal.

•When the Input Search function is set On1 or On2, the input signal will be searched automatically (p.45)

http://www.pureglare.com.au 35