Sanyo PDG-DWL2500 owner manual Part Names and Functions Side Terminal

Part Names and Functions

Side Terminal

q w e r t y u i

o !0 !1 !2

qS-VIDEO IN

Connect the S-VIDEO output signal from video equipment to this jack (p.17).

wVIDEO IN

Connect the composite video output signal to this jack (p.17).

eAUDIO IN

Connect the audio output signal from video equipment connected to q or w to this jack. For a monaural audio signal (a single audio jack), connect it to the L (MONO) jack (p.17).

rCOMPUTER 1/COMPONENT AUDIO IN

Connect the audio output (stereo) from a computer or video equipment connected to !0or !2to this jack (pp.16, 18).

tCOMPUTER 2 AUDIO IN

Connect the audio output (stereo) from a computer connected to !1to this jack (pp.16, 18).

yAUDIO OUT (VARIABLE)

Connect an external audio amplifier to this jack (pp.16-18).

This terminal outputs sound from AUDIO IN terminal (e, r or t) or HDMI terminal !2(digital audio).

uCONTROL PORT

When controlling the projector with RS-232C, connect the control equipment to this connector with the serial control cable.

i3D SYNC OUT

Connect a 3D sync. signal cable for an IR wireless emitter to this jack (p.48)

oLAN Connection Terminal

Connect the LAN cable (refer to the owner’s manual of "Network Set-up and Operation").

!0COMPUTER IN 1/COMPONENT IN

Connect output signal from a computer, RGB scart 21-pin video output or component video output to this terminal (pp.16, 18).

!1COMPUTER IN 2/MONITOR OUT

This terminal is switchable and can be used for input from a computer or output to the other monitor.

Set the terminal up as either Computer input or Monitor output properly. [Used for Monitor out, this terminal outputs only incoming signal from COMPUTER IN 1/COMPONENT IN terminal (pp. 16, 56)].

!2HDMI

Connect the HDMI signal from computer or video equipment to this terminal (pp.16, 18).

11