Sanyo PDG-DWL2500 owner manual Appendix, Troubleshooting

Appendix

Troubleshooting

Before calling your dealer or service center for assistance, check the items below once again.

–Make sure you have properly connected the projector to peripheral equipment as described on pages 16-18.

–Make sure all equipment is connected to AC outlet and the power is turned on.

–When the projector does not project an image from the connected computer, restart the computer.

Power

Opening display

Image

Problem	Solutions	Pages
No power	q Plug the power cord of the projector into the AC outlet.
	q See if the POWER indicator lights red.
	q Wait until the POWER indicator stops blinking to turn on the	20
	projector again. The projector can be turned on after the
	POWER indicator turns red.
	q Check the WARNING indicator. If the WARNING TEMP.	64
	indicator lights red, projector can not be turned on.
	q Check the projection lamp.	67
	q Unlock the Key lock function for the projector.	59
PIN code dialog box appears at	q PIN code lock is being set. Enter a PIN code (the “1234” or	21,
start-up.	numbers you have set.)	59-60
The initial display is not shown.	q Make sure Off or Countdown off are not chosen at display	53
	function.
The initial display is not same	q Make sure User or Off are not chosen at Logo (select)	53
as the default set.	function.
Input signal switches automati-	q Make sure Input search function is adjusted properly.	51
cally. (or does not switch auto-
matically)
An icon other than Input mode	q That is the Filter warning icon or the Lamp replacement icon.	62, 67
or Lamp mode icon appears
No image	q Check the connection between your computer or video	16-18
	equipment and the projector.
	q See if the input signal is correctly output from your computer.
	Some laptop computers may need to change the setting for
	monitor output when connecting to a projector. See your
	computer’s instruction manual for the setting.
	q It takes about 30 seconds to display an image after turning on	20
	the projector.
	q Check the Input signal, color system, video system or
	computer system mode.
	q Make sure the temperature is not out of the specified
	Operating Temperature (41˚F–95˚F [5˚C–40˚C]).
	q When No Show is operating, the image can not be displayed.
	Press the NO SHOW button or any other button on the remote
	control.
Image is Left/Right reversed.	q Check the Ceiling/Rear function.	40, 47
Image is Top/Bottom reversed.	q Check the Ceiling function.	40, 47

69