Setting
Power management
For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not operated for a certain period.
Select one of the following options:
Ready | When the lamp has been fully cooled |
| down, the POWER indicator changes |
| to green blinking. In this condition, the |
| projection lamp will be turned on if the |
| input signal is reconnected or any button |
| on the remote control is pressed. |
Shut down | When the lamp has been fully cooled |
| down, the power will be turned off. |
Off | Power management function is off. |
Timer | If the input signal is interrupted and |
| no button is pressed for more than |
| 30 seconds, the timer display with No |
| signal appears. It starts the countdown |
| until the lamp is turned off. Use the Point |
| ed buttons to set the Timer(1~30Min). |
4Note:
Factory default is Ready: 5 Min.
Direct on
When this function is set to On, the projector will be automatically turned on just by connecting the AC power cord to a wall outlet.
4Note:
Be sure to turn off the projector properly (see “Turning Off the Projector” on page 22). If the projector is turned off in the incorrect sequence, the Direct on function does not work properly.
Power management
Timer left before Lamp is off.
57