Setting
HDMI setup
This function is only used for HDMI input source.
Image
Select Normal or Enhanced to match the video range setting of your HDMI Digital RGB equipment.
Sound
HDMI........... When using the HDMI cable, select HDMI.
Both video and audio* are transferred and you need not to connect any additional cables for audio.
* This HDMI terminal supports Linear PCM (32kHz/44.1kHz/48kHz).
Computer... When using the
The names for the output setting of Digital RGB vary from equipment to equipment. For details, refer to the owner’s manual of your Digital RGB equipment.
When the black parts of the image are destroyed or stand out, please switch to Normal or Enhanced, and then switch the output type of the HDMI Digital RGB output equipment.
Terminal
The COMPUTER IN 2/MONITOR OUT terminal on the back of the projector is switchable for computer input or monitor output (p.11).
Computer 2……Computer input
Monitor out……Monitor output
Terminal function is not available when Computer 2 to the input source is selected. Change the input source to the others (Computer 1, Video,
Standby mode
This function is available when operating the projector via network.
Network..... Supply the power to the network function even
after turning off the projector. You can turn on/ off the projector via network, modify network environment, and receive an
Eco............. Select Eco when you do not use the projector
via network. The projector’s network function will stop when turning off the projector.
Refer to the owner’s manual of “Network
HDMI setup
4Note:
•Factory default is Network.
•When Eco is selected and the projector is in
56