Hitachi CP-X955W/E specifications Plug & Play, Press the STANDBY/ON button, for 1 second

Page 13

Basic operations (continued)

To turn off the power

1

1	STANDBY/ON	MUTE
	STANDBY/ON	MUTE
	FOCUS ZOOM	VOLUME
	POSITION ON	LASER

2	RESET	RIGHT
2	MENU ON	MOUSE ON
	BLANK	TIMER
	RGB 1/2	VIDEO 1/2

3

INPUT

1 Press the STANDBY/ON button, for 1 second.

•The ON indicator lights up orange and the lamp turns off. (About 1 minute later), the fan stops and the indicator blinks orange.

•Press the STANDBY/ON button for short time (less than 1 second), the projector do not set in standby mode.

2

3

Turn the MAIN POWER switch of the projector off. [ª: OFF]

Turn the lens cover lever up.

• Lens cover closes.

Caution Do not turn off the MAIN POWER switch before pressing the STANDBY/ON button. After

the STANDBY/ON button is pressed, the fan rotates for about 1 minute to cool the projector. Do not turn off the MAIN POWER switch during the lamp on because the lamp is damaged.

PLUG & PLAY

This projector complies with VESA DDC1/2B specifications. PLUG & PLAY is a system with computer, peripherals (including projectors), and operating system.

It works when the projector is connected to DDC (Display Data Channel) ready computer that is running an operating system software that incorporates plug & play functionality.

(Only RGB 1)

13

Image 13

Contents ContentsPage FeaturesOutline Operating GuideFor the Customers in U.K Power cord Video signal cablesBefore use Video inputsLDo not install this unit in an unstable Do not look directly at the lens when the lamp is litDo not use power supplies LIf any abnormality occursDo not stare directly into the laser Aperture Be careful in handling the power cordCleaning Handle the power cord carefullyClean inside the unit at least once two years When you are not going to use for a long timeVolume Do not place this unit where it gets hotCleaning the lens Cleaning the cabinetMain unit Names and functions of each partStandby / on Laser on Remote control transmitterDisk PAD Remove the battery compartment cover Installation of liquid crystal projector InstallationView from the top View from the side View from the front View from the sideTo project the picture Basic operationsPress the STANDBY/ON button, for 1 second Plug & PlayPress the Menu buttons or the Menu on / OFF button Adjustments and functionsBrightness SET UPColor SizeImage InputBlank OPT. OptionReveal COM. Bits LanguageConnection to the RGB signal terminal Connection to the video signal terminalsExample of computer signal Connection to the RGB signal terminalData Hsync Initial set signalsControl signal terminal Connection to the control signal terminalMouse emulation Connection to the control signal terminal Communication Control command codeControl data table Procedure of getting the Projector status Cleaning the air filter Example of system setupConnecting various equipment Re-install the air filter Clean the air filter using a vacuum cleanerLamp Message tableIndicator display When you think something wrongDimension diagram