Hitachi CP-X955W/E Do not place this unit where it gets hot, Volume, Cleaning the lens

Page 7

Caution

[General cautions]

LDo not place this unit where it gets hot.

Be careful since if you place the unit outdoors, in a place exposed to direct sunlight or near a heating device, the cabinet and parts could be affected.

LVolume.

Use at the proper volume level so that it does not bother persons in the neighborhood. Especially, since the sound is likely to carry well at the night even at a low volume, consider the neighborhood to a good living environment.

LCleaning the lens.

To clean the lens, use a generally- available lens cleaning tissue (used for cleaning lens of camera, glasses, etc.). Be careful not to scratch the lens with a hard object.

LCleaning the cabinet.

Since many plastic materials are used on the surface of the cabinet, if the surface is cleaned

using benzene, thinner, etc., it may change in quality or the coating may be peeled off. Avoid

using chemicals.

When a chemically-teated cloth is used, follow the cautions that come with the cloth.

Do not spray a volatile agent such as insecticide on the unit. Do not leave a rubber or vinyl

object touching the cabinet for a long time. It may cause the cabinet to change in quality or the

coating to peel off.

Clean the dirt from the cabinet and operation panel by dusting lightly with soft cloth. If the

dirt is conspicuous, wipe off with a cloth moistened with detergent diluted with water, then wipe off with a dry soft cloth.

LRest your eyes occasionally when viewing for a long time.

7

Image 7
Contents Operating Guide FeaturesContentsPage OutlineFor the Customers in U.K Video inputs Video signal cablesPower cord Before useLIf any abnormality occurs Do not look directly at the lens when the lamp is litLDo not install this unit in an unstable Do not use power suppliesDo not stare directly into the laser Aperture Be careful in handling the power cordWhen you are not going to use for a long time Handle the power cord carefullyCleaning Clean inside the unit at least once two yearsCleaning the cabinet Do not place this unit where it gets hotVolume Cleaning the lensMain unit Names and functions of each partStandby / on Laser on Remote control transmitterDisk PAD Remove the battery compartment cover View from the front View from the side InstallationInstallation of liquid crystal projector View from the top View from the sideTo project the picture Basic operationsPress the STANDBY/ON button, for 1 second Plug & PlayPress the Menu buttons or the Menu on / OFF button Adjustments and functionsSize SET UPBrightness ColorImage InputBlank OPT. OptionReveal COM. Bits LanguageConnection to the RGB signal terminal Connection to the video signal terminalsExample of computer signal Connection to the RGB signal terminalData Hsync Initial set signalsControl signal terminal Connection to the control signal terminalMouse emulation Connection to the control signal terminal Communication Control command codeControl data table Procedure of getting the Projector status Cleaning the air filter Example of system setupConnecting various equipment Message table Clean the air filter using a vacuum cleanerRe-install the air filter LampIndicator display When you think something wrongDimension diagram