Warning
LBe careful in handling the power cord.
•Do not scratch, damage or process the power cord. Do not bend it forcibly. Also do not put a
heavy object on it, do not heat it and do not pull it. If you do, the power cord may be damaged and it may cause a fire, electric shock, etc.
•Do not pull the cord.
•Do not put a heavy object on it.
•Do not damage the cord.
•Do not put it near a heating device.
•Be careful that this unit is not placed on the power cord. The power cord may be damaged and it may cause a fire, electric shock, etc. If the cord is covered with a carpet, etc. a heavy object may be put on it without your realizing it.
•If the cord is damaged (core wire is exposed, disconnected, etc.), ask
your dealer to replace it. It may cause a fire, electric shock, etc.
•Check that no dirt adheres to the power plug and fully insert without any play. If dirt adheres or the connection is incomplete, it may cause a fire, electric shock, etc.
•The outer shield of power cord must be connected to ground.
If you do not, it may cause a electric shock.
LDo not stare directly into the laser
aperture.
•The laser pointer on the remote control unit radiates the laser beam
from the laser aperture.
•Do not stare into the laser aperture or radiate the laser beam to other persons as the laser emitted
is a class II laser and it could damage you vision, etc.
Especially pay attention if children are present.
•The three labels below are caution labels for the laser beam.
AVOIDE
RADIATION IS EMITTED
FROM THIS APERTURE
LASER APERTURE
C A U T I O N
LASER RADIATION-
DO NOT STARE INTO BEAM
WAVE LENGTH:670nm
MAX. OUTPUT:1mW
CLASS II LASER PRODUCT
RADIAZIONI LASER
NON GUARDARE NEL RAGGIO LUCE APPARECCHIO LASER DI CLASSE 2
RAYONNEMENT LASER | MANUFACTURED |
NE PAS REGARDER DANS |
|
LE FAISCEAU APPAREIL | |
A LASER DE CLASSE 2 |
|
| |
NICHT IN DEN STRAHL |
|
BLICKEN LASER KLASSE2 | MANUFACTURER:A |
| MADE IN JAPAN |
5