Hitachi CP-X955W/E Example of system setup, Cleaning the air filter, Connecting various equipment

Page 27

Example of system setup

Connecting various equipment.

AC Inlet
VCR with S-VHS out (video model only)	Computer (Note type)
	Computer (Note type)

Audio amplifying equipment

VCR, etc. (video model only)

Computer (Desk type)

CRT Display

Caution Turn power off to all devices before connecting.

Refer to the instruction manual of each device before connecting.

Cleaning the air filter

Clean the air filter about every 100 hours or when “CHECK THE AIR FLOW” is displayed.

1 Turn off the MAIN POWER switch of the projector and pull out the power cord.

2 Remove the air filter from the bottom.

27

Image 27

Contents Operating Guide FeaturesContentsPage OutlineFor the Customers in U.K Video inputs Video signal cablesPower cord Before useLIf any abnormality occurs Do not look directly at the lens when the lamp is litLDo not install this unit in an unstable Do not use power suppliesDo not stare directly into the laser Aperture Be careful in handling the power cordWhen you are not going to use for a long time Handle the power cord carefullyCleaning Clean inside the unit at least once two yearsCleaning the cabinet Do not place this unit where it gets hotVolume Cleaning the lensNames and functions of each part Main unitStandby / on Remote control transmitter Laser onDisk PAD Remove the battery compartment cover View from the front View from the side InstallationInstallation of liquid crystal projector View from the top View from the sideTo project the picture Basic operationsPress the STANDBY/ON button, for 1 second Plug & PlayPress the Menu buttons or the Menu on / OFF button Adjustments and functionsSize SET UPBrightness ColorImage InputOPT. Option BlankReveal COM. Bits LanguageConnection to the RGB signal terminal Connection to the video signal terminalsExample of computer signal Connection to the RGB signal terminalData Hsync Initial set signalsConnection to the control signal terminal Control signal terminalMouse emulation Connection to the control signal terminal Communication Control command codeControl data table Procedure of getting the Projector status Example of system setup Cleaning the air filterConnecting various equipment Message table Clean the air filter using a vacuum cleanerRe-install the air filter LampIndicator display When you think something wrongDimension diagram