Hitachi instruction manual Appearance and Names of Parts, Appearance of SJ2-CO

Page 6

CHAPTER 1 INTRODUCTION

1.3 Appearance and Names of Parts

LED display

Power supply(POW)

Inverter Status(RUN)

Inverter condition mode(MOD)

CANbus Status(CAN)

Bus ready

(in CANopen this LED always green) Baud rate & Node ID setting(See 4.1.2)

CAN bus Interface

Figure 1-1 Appearance of SJ2-CO

2

Image 6

Contents Hitachi Inverter Revision History Table Safty Precautions Otherwise, there is a danger of electric shock and/or injury Warranty of the product Request upon inquiringAppearance and Names of Parts Appearance of SJ2-COSpecifications Label CANopen Support VersionLED display Installation of SJ2-CO SJ200-2 + SJ2-CO Mounting method of optionSJ2-MF SJ2-CCV Connection for CANopen connector Communication cable for CANopenWiring note PLCSetting methods of Baud rate and Node ID Setting method of CANopen Baud rateSetting method of CANopen Node Parameter setting of the Inverter Power Supply LED checkCanopen Communication Function PDOProcess Data Object Device Control Object Dictionary for Standardized Device Profile AreaAbortconnectionoptioncode Index 6007h Control word Index 6040h Status word Index 6041h Power State MachineUsing RFGRamp Function Generator RFGVlvelocityeffort Index 6044h Vltargetvelocity Index 6042hVlvelocitydemand Index 6043h Vlvelocityminmaxamount Index 6046hVlvelocityacceleration Index 6048h Vlvelocitydeceleration Index 6049hModesofoperation Index 6060h/6061h Keypad displayOPTIONAL OPERATOROPE-SRMINITrip display Protection function listCountermeasure for a trip state LED display and Countermeasure LEDCommunication Objects Device Profile AreaProfile Manufacyure Objects d,F group IndexProfile Manufacture Objects A,b,C,H,P group Parameter Communication Objects Lists Communication Objects Lists Saving Parameters to Eeprom Dimension Contact Information