Kodak E30 manual Troubleshooting, Condition Cause Correction

Troubleshooting

Use this chart to solve common problems. If you fail to find the solution, contact your local dealer for assistance and service.

CONDITION CAUSE CORRECTION

The power switch is	• Is the power cord	• Connect the power cord	ENGLISH
“ON” but the machine	disconnected?	on power source.
does not operate.	• Is the fuse blown?	• Replace the blown fuse.
	• Is the TOP COVER	• Close the TOP COVER
	completely closed?	completely.
The power switch is	• Is the lamp installed	• Set the lamp securely.
“ON”, the fan is rotat-	securely?
ing, but the lamp	• Is the lamp burned out?	• Replace the lamp.
does not come on.	• Is the LAMP CHANGE	• Move the LAMP CHANGER
	HANDLE in the right	HANDLE firmly to the right
	position?	(or left) position then turn
		the power switch “ON”
		again to reset the power.
The power switch is	• Is the PROJECTION	• Raise the PROJECTION
“ON” the lamp is on,	MIRROR open, and	MIRROR on the head and
but there is no pro-	properly tilted up?	tilt it to project image for-
jected image.		ward.
The image is blurred.	• Is the distance between	• Position the projector
	the screen and projection	1.3 - 4 meters from the
	too far or too close?	screen.
	• Is the “UP” label on the	• Reinstall the Fresnel lens
	Fresnel lens facing the	with the “UP” label facing
	stage glass?	the stage glass making
		sure to secure it with the
		clip holders.
	• Is the projected image out	• Adjust the focus knob on
	of focus?	arm to have a good focus.
	• Is the transparency flat?	• Ensure that the trans-
		parency is flat.
The light is not bright	• Has the lamp been in use	• Replace the lamp. Or use
enough.	for a long time?	LAMP CHANGE HANDLE
		to switch to a new lamp.
Power is suddenly	• Is the fuse blown?	• Replace the fuse.
lost during use.	• Connection has been lost	• Check the main power
	with main power?	cable for right connection.

11KODAK EKTALITE E30/E31 OVERHEAD PROJECTORS