Fluke Network Tester user manual Select

NetTool

Users Manual

4.To change what NetTool is viewing in real-time and to change the direction (that is, “to/from Network” or “to/from PC”), move the cursor to the desired device icon (located in the upper right or left). Then press

SELECT.

6.To change how the data is expressed (in “per seconds” or as a percentage of current activity), move the cursor to the reading below a meter then press

SELECT

Note

Use this information to make comparisons. For example, you may see a high percentage of network utilization and observe that the PC is also registering high utilization.

5.To segment what the PC is doing to contribute to a high utilization statistic (for example, broadcasts), move the cursor to Util then press SELECT.

If you exit the Health screen and return later without powering off the tester, NetTool displays the last-saved settings. If you power off NetTool while viewing the Health screen, readings are not saved. Display the Setup screen and select Restore Defaults to restore the factory settings.

4-4