Primera Technology LX900 user manual Roll Guide

Page 13

TOC

INDEX

3.Remove any shipping tape from your label stock roll to ensure that it can unroll freely, making certain that no adhesive portion is exposed. It is important to note that any exposed adhesive surface can attach itself the the inner workings of the print mechanism and cause a media jam.

4.Place your roll of label stock on the Roll Arm and push it inward until it touches the Roll Stop.

Roll Stop

Roll Guide

DO NOT PINCH

 

Roll Arm

5.Flip up the Roll Guide and slide it inward until it touches the label stock. The Roll Guide will automatically pull back slightly to the correct position. There should be approxi- mately a 1mm gap between the roll guide and the roll.

Important Note: Be aware that some label stock may have a core that is slightly too large for the roll or the labels may have wrapped unevenly causing some to stick out beyond the edge of the core. Both of these issues can cause feeding problems.

Label Stock 9

Image 13
Contents 062211-511271 All rights reserved Printing History Table of Contents Interactive Feature Thank YOU… Getting StartedChoosing a Good Location Unpacking and Inspection Identifying the Parts Recommended PC Specifications Computer SpecificationsLabel Stock Label and Roll SpecificationsTOC Index Label Side Out Roll O.D Installing Label Stock Roll Guide Movable Throat Guide Fixed Throat Guide Circular Labels Adjusting the Label Stock TOF TOP of Form SensorThrough-Hole Labels SET the Stock Sensor Mode SET the Output Mode TOC Ink Cartridges Status Monitor Monitoring INK Levels Using the Cost Estimator Replacing INK Cartridges / LOW INK Warning TOC TOC Printing Using NicelabelTOC TOC TOC TOC TOC Creating Barcodes in Nicelabel RSS TOC Printing from Other Programs Adjusting Print Alignment TOC Creating a Full Bleed Print Printer Driver Settings To find Driver Settings Portrait Landscape Paper SizeColor Matching Ink Saturation Solving Print Alignment Problems Troubleshooting and MaintenanceImage is Vertically Offset Image is printing horizontally offset Solving Print Quality Problems Maintenance Station Color Matching and Design Tips DPI Image printed with the LX900 TOC Create a Support Report Cleaning the PrinterCleaning the Printhead 3C. Preventing clogged nozzles 3B. Deep clean the cartridgeSemi-Permanent Print Head Part Number Printhead / Cartridge Replacement ProcedureInk Feed Unload Press Pause + Load/Feed to Start and Finish Replacing the PrintheadTOC Now align the print head as described in B Explanation Interpreting the PRINTER’S Indicator LightsTechnical Support Source LocationMedia Types Section Technical SpecificationsDPI Index11, 33, 35