Primera Technology LX900 user manual Toc

Page 37

TOC

INDEX

Adjust print alignment using the Status Monitor. Go to the Alignment Tab (third tab).

Three items can be adjusted here:

Tear off Position. This value adjusts the position of the last label printed after it has been presented for tear off. This only applies if the output mode is set to "Yes" Present the label. Add to the current value to move the tear point clos- er to the printer. Subtract from the current value to move the tear point away from the printer. After adjusting the value click the Set button to send the value to the printer.

Left Margin Offset. This value moves the printed label left or right. Add to the current value to move the printed label to the right. Subtract from the current value to move the printed label to the left. After adjusting the value, click the “Set” button to send the value to the printer. Note: Before adjusting this value make sure the label stock is properly loaded so that there is no gap between the edge of the liner and the fixed throat guide. Any gap at this point will greatly affect the Left margin offset value

needed to align the label. Also, if you adjust the value with improperly loaded label stock you will have to adjust it again if you load the label stock correctly the next time.

Top of Form (TOF). This value moves the print start position up or down on the label. Add to the current value to move the printed label down or toward the printer. Subtract from the current value to move the printed label up or away from the printer. After adjusting the value click the “Set” button to send the value to the printer.

Printing 33

Image 37
Contents 062211-511271 All rights reserved Printing History Table of Contents Interactive Feature Thank YOU… Getting StartedChoosing a Good Location Unpacking and Inspection Identifying the Parts Recommended PC Specifications Computer SpecificationsLabel Stock Label and Roll SpecificationsTOC Index Label Side Out Roll O.D Installing Label Stock Roll Guide Movable Throat Guide Fixed Throat Guide Circular Labels Adjusting the Label Stock TOF TOP of Form SensorThrough-Hole Labels SET the Stock Sensor Mode SET the Output Mode TOC Ink Cartridges Status Monitor Monitoring INK Levels Using the Cost Estimator Replacing INK Cartridges / LOW INK Warning TOC TOC Printing Using NicelabelTOC TOC TOC TOC TOC Creating Barcodes in Nicelabel RSS TOC Printing from Other Programs Adjusting Print Alignment TOC Creating a Full Bleed Print Printer Driver Settings To find Driver Settings Portrait Landscape Paper SizeColor Matching Ink Saturation Solving Print Alignment Problems Troubleshooting and MaintenanceImage is Vertically Offset Image is printing horizontally offset Solving Print Quality Problems Maintenance Station Color Matching and Design Tips DPI Image printed with the LX900 TOC Create a Support Report Cleaning the PrinterCleaning the Printhead 3C. Preventing clogged nozzles 3B. Deep clean the cartridgeSemi-Permanent Print Head Part Number Printhead / Cartridge Replacement ProcedureInk Feed Unload Press Pause + Load/Feed to Start and Finish Replacing the PrintheadTOC Now align the print head as described in B Explanation Interpreting the PRINTER’S Indicator LightsTechnical Support Source LocationMedia Types Section Technical SpecificationsDPI Index11, 33, 35