Primera Technology LX900 user manual Through-Hole Labels

Page 16

TOC

INDEX

The sensor can only be moved a maximum of 2.3 inches from the left side of the printable area. This means that the maximum diameter circular label that can be printed is 4.6 inches. For circular labels larger than 4.6 inches in diameter, you must have a black mark printed on the back of the label stock. This means that you must change the Stock Sensor Mode to Reflective. The printer will now look for the black mark representing the beginning of the next label instead of the diecut. For more information on changing the Stock Sensor Mode see Section 2D.

1/2”

1 1/8”

Center

of Hole

Center

of Circle

Through-Hole Labels

Circular Labels

Set Sensor Bar to 1 1/8" for 2" circular label (1/8" liner edge gap).

Through-Hole Labels

If you are using card stock or label stock that has a hole punch or a notch to identify a transition from backing to label, you can adjust the Stock Sensor to position it over the identifying mark.

12Label Stock

Image 16
Contents 062211-511271 All rights reserved Printing History Table of Contents Interactive Feature Thank YOU… Getting StartedChoosing a Good Location Unpacking and Inspection Identifying the Parts Computer Specifications Recommended PC SpecificationsLabel and Roll Specifications Label StockTOC Index Label Side Out Roll O.D Installing Label Stock Roll Guide Movable Throat Guide Fixed Throat Guide Adjusting the Label Stock TOF TOP of Form Sensor Circular LabelsThrough-Hole Labels SET the Stock Sensor Mode SET the Output Mode TOC Ink Cartridges Status Monitor Monitoring INK Levels Using the Cost Estimator Replacing INK Cartridges / LOW INK Warning TOC TOC Using Nicelabel PrintingTOC TOC TOC TOC TOC Creating Barcodes in Nicelabel RSS TOC Printing from Other Programs Adjusting Print Alignment TOC Creating a Full Bleed Print Printer Driver Settings To find Driver Settings Paper Size Portrait LandscapeColor Matching Ink Saturation Solving Print Alignment Problems Troubleshooting and MaintenanceImage is Vertically Offset Image is printing horizontally offset Solving Print Quality Problems Maintenance Station Color Matching and Design Tips DPI Image printed with the LX900 TOC Cleaning the Printer Create a Support ReportCleaning the Printhead 3B. Deep clean the cartridge 3C. Preventing clogged nozzlesPrinthead / Cartridge Replacement Procedure Semi-Permanent Print Head Part NumberReplacing the Printhead Ink Feed Unload Press Pause + Load/Feed to Start and FinishTOC Now align the print head as described in B Interpreting the PRINTER’S Indicator Lights ExplanationTechnical Support Source LocationSection Technical Specifications Media TypesIndex DPI11, 33, 35