Primera Technology LX900 user manual Ink Saturation

Page 43

TOC

INDEX

Best for Photos mode is best used for photographic images where accurate color reproduction is very essential. Images printed in this mode will look lighter than those printed in Photo mode. Skin tones especially will look more natural in this mode.

NOTE: Exact color matching of the printed labels to the screen may never be possible since there are factors that affect this out of the drivers control. The surface of the label reacts with the ink in the cartridge to produce the color. For this reason, when printing the same image to different types of labels with different surfaces the printed output can look entirely different.

Ink Saturation

This option controls the amount of ink used when printing an image. The default setting is 100%, which will provide the most accurate color matching. If the ink is not drying fast enough or bleeding, you can decrease the Ink Saturation to lessen the amount of ink that is applied to the label.

Enable Bi-di Printing

This setting defaults to “Yes” for fastest bidirectional printing.

Stock Sensor Mode

Click this setting to open the Status Monitor. See Section 2D

Output Mode

Click this setting to open the Status Monitor. See Section 2E

Print Alignment

Click this setting to open the Status Monitor. See Section 4D

Cartridge Maintenance

Click this setting to Align the Printhead, Clean the Printhead or Change a Cartridge. This setting opens the Status Monitor.

Printing 39

Image 43

Contents 062211-511271 All rights reserved Printing History Table of Contents Interactive Feature Thank YOU… Getting StartedChoosing a Good Location Unpacking and Inspection Identifying the Parts Recommended PC Specifications Computer SpecificationsLabel Stock Label and Roll SpecificationsTOC Index Label Side Out Roll O.D Installing Label Stock Roll Guide Movable Throat Guide Fixed Throat Guide Circular Labels Adjusting the Label Stock TOF TOP of Form SensorThrough-Hole Labels SET the Stock Sensor Mode SET the Output Mode TOC Ink Cartridges Status Monitor Monitoring INK Levels Using the Cost Estimator Replacing INK Cartridges / LOW INK Warning TOC TOC Printing Using NicelabelTOC TOC TOC TOC TOC Creating Barcodes in Nicelabel RSS TOC Printing from Other Programs Adjusting Print Alignment TOC Creating a Full Bleed Print Printer Driver Settings To find Driver Settings Portrait Landscape Paper SizeColor Matching Ink Saturation Solving Print Alignment Problems Troubleshooting and MaintenanceImage is Vertically Offset Image is printing horizontally offset Solving Print Quality Problems Maintenance Station Color Matching and Design Tips DPI Image printed with the LX900 TOC Create a Support Report Cleaning the PrinterCleaning the Printhead 3C. Preventing clogged nozzles 3B. Deep clean the cartridgeSemi-Permanent Print Head Part Number Printhead / Cartridge Replacement ProcedureInk Feed Unload Press Pause + Load/Feed to Start and Finish Replacing the PrintheadTOC Now align the print head as described in B Source Location Interpreting the PRINTER’S Indicator LightsExplanation Technical SupportMedia Types Section Technical SpecificationsDPI Index11, 33, 35