Primera Technology LX900 user manual Replacing INK Cartridges / LOW INK Warning

Page 23

TOC

INDEX

C. REPLACING INK CARTRIDGES / LOW INK WARNING

You can replace cartridges at any time or wait for the Low Ink Warning to prompt you to replace cartridges. Low Ink Warnings occur at the following levels:

10% - If any cartridge is lower than 10% at the beginning of a job you will be prompted to change that cartridge. At this point you can change or ignore.

0% - If any cartridge reaches 0% during a job you will be prompted to change that cartridge. At this point you can change or ignore. Under normal circumstances this will be your first warning. The 10% warning is only triggered at the start of a job.

-10%- If at any point any cartridge is -10% you will be prompted to change that cartridge. You must change the cartridge to continue.

To change a cartridge, follow this procedure:

1.Press Pause and Load/Feed simultaneously -OR- click the Change Cartridge button on the second tab of the Status Monitor. The head carriage will move to the center of the print area for easy access.

Ink Cartridges 19

Image 23
Contents 062211-511271 All rights reserved Printing History Table of Contents Interactive Feature Choosing a Good Location Getting StartedThank YOU… Unpacking and Inspection Identifying the Parts Recommended PC Specifications Computer SpecificationsLabel Stock Label and Roll SpecificationsTOC Index Label Side Out Roll O.D Installing Label Stock Roll Guide Movable Throat Guide Fixed Throat Guide Circular Labels Adjusting the Label Stock TOF TOP of Form SensorThrough-Hole Labels SET the Stock Sensor Mode SET the Output Mode TOC Ink Cartridges Status Monitor Monitoring INK Levels Using the Cost Estimator Replacing INK Cartridges / LOW INK Warning TOC TOC Printing Using NicelabelTOC TOC TOC TOC TOC Creating Barcodes in Nicelabel RSS TOC Printing from Other Programs Adjusting Print Alignment TOC Creating a Full Bleed Print Printer Driver Settings To find Driver Settings Portrait Landscape Paper SizeColor Matching Ink Saturation Image is Vertically Offset Troubleshooting and MaintenanceSolving Print Alignment Problems Image is printing horizontally offset Solving Print Quality Problems Maintenance Station Color Matching and Design Tips DPI Image printed with the LX900 TOC Create a Support Report Cleaning the PrinterCleaning the Printhead 3C. Preventing clogged nozzles 3B. Deep clean the cartridgeSemi-Permanent Print Head Part Number Printhead / Cartridge Replacement ProcedureInk Feed Unload Press Pause + Load/Feed to Start and Finish Replacing the PrintheadTOC Now align the print head as described in B Source Location Interpreting the PRINTER’S Indicator LightsExplanation Technical SupportMedia Types Section Technical SpecificationsDPI Index11, 33, 35