Primera Technology LX900 user manual Movable Throat Guide Fixed Throat Guide

Page 14

TOC

INDEX

6.Pull the Movable Throat Guide outward to make room for the label stock.

7.Place the leading edge of the label stock under

the "label stock" symbols on the Throat Guides. LabelStock The label stock should be placed far enough into the throat of the printer to correctly position the Movable Throat Guide but not yet into the printer itself.

Movable Throat Guide

Fixed Throat Guide

 

DO NOT PINCH

8.Slide the Movable Throat Guide inward until it almost touches the label stock.

Important Note: The label stock should be close enough to the Fixed and Movable Thoat Guides to provide proper guidance but not close enough to pinch the label stock. (0-1 mm gap on either side)

If the label stock is pinched by the guides, poor print quality or feeding problems could result.

9.Feed the label stock further into the printer until it senses the label and automatically feeds it through the printer. If the printer fails to feed the label stock, press the Load/Feed button on the front panel while continuing to guide the label stock into the printer. If the printer does not automatically grab and feed the stock or continues to feed the stock without stopping check the Stock Sensor position or mode (Section 2C or 2D).

10Label Stock

Image 14
Contents 062211-511271 All rights reserved Printing History Table of Contents Interactive Feature Choosing a Good Location Getting StartedThank YOU… Unpacking and Inspection Identifying the Parts Computer Specifications Recommended PC SpecificationsLabel and Roll Specifications Label StockTOC Index Label Side Out Roll O.D Installing Label Stock Roll Guide Movable Throat Guide Fixed Throat Guide Adjusting the Label Stock TOF TOP of Form Sensor Circular LabelsThrough-Hole Labels SET the Stock Sensor Mode SET the Output Mode TOC Ink Cartridges Status Monitor Monitoring INK Levels Using the Cost Estimator Replacing INK Cartridges / LOW INK Warning TOC TOC Using Nicelabel PrintingTOC TOC TOC TOC TOC Creating Barcodes in Nicelabel RSS TOC Printing from Other Programs Adjusting Print Alignment TOC Creating a Full Bleed Print Printer Driver Settings To find Driver Settings Paper Size Portrait LandscapeColor Matching Ink Saturation Image is Vertically Offset Troubleshooting and MaintenanceSolving Print Alignment Problems Image is printing horizontally offset Solving Print Quality Problems Maintenance Station Color Matching and Design Tips DPI Image printed with the LX900 TOC Cleaning the Printer Create a Support ReportCleaning the Printhead 3B. Deep clean the cartridge 3C. Preventing clogged nozzlesPrinthead / Cartridge Replacement Procedure Semi-Permanent Print Head Part NumberReplacing the Printhead Ink Feed Unload Press Pause + Load/Feed to Start and FinishTOC Now align the print head as described in B Technical Support Interpreting the PRINTER’S Indicator LightsExplanation Source LocationSection Technical Specifications Media TypesIndex DPI11, 33, 35